User manual WHIRLPOOL AWZ 220/1 INSTRUCTION FOR USE

[. . . ] For reduced spinning speed a longer drying time should be selected. Drying times may be longer for towelling and heavier items. 5019 307 00156 PREPARING THE LAUNDRY 1. Check that all fastenings are closed and that pockets are empty. [. . . ] Place laundry loosely in the drum to make sure it doesn’t become tangled. Sort laundry as follows: A) By care symbols (on the collar or inside seam): Suitable for tumble drying Tumble drying with reduced drying intensity only Do not tumble dry B) By amount and thickness/weight Whenever the load to be dried exceeds dryer capacity, separate laundry according to weight (e. g. C) By type of fabrics Cotton/linen: Towels, cotton jersey, bed and table linen made of cotton or linen. Synthetics/Easy Care: Blouses, shirts, overalls, etc. made of polyester or polyamide, as well as cotton/synthetic mixes. D) By drying level • Sort into: iron dry, cupboard dry, etc. Do not tumble dry: Woollens, silk, nylon stockings, delicate embroidery, fabrics with metallic decorations, bulky items such as sleeping bags, etc. Important: only use specific indicated dryersafe additives and rinse items that have been treated with stain remover thoroughly in plenty of water before drying. Remove lint using a soft brush or your fingertips. BUILT-IN INSTALLATION To built in the dryer 1. It is recommended to not remove the worktop. Connect the dryer to an external ventilation system in order to prevent steam from damaging your furniture during the years. TROUBLESHOOTING GUIDE If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • Was the correct drying time selected?• Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm)?• Is the lint filter dirty (filter indicator lamp on)?The dryer does not operate: • Is the power plug properly inserted into the mains electricity socket? [. . . ] The dryer does not operate: • Is the power plug properly inserted into the mains electricity socket?• Has the drying time been selected?• Has the Start button been pressed? [. . . ]