User manual WHIRLPOOL AWZ 3306 INSTRUCTION FOR USE

[. . . ] Press the Start/Pause button to confirm your final selection. Start delay indicator blinks and the countdown is running by reducing the time in one hour steps. The countdown is indicated by the blinking of the start delay indicator located in the button. During count-down the drum will turn from time to time to redistribute the laundry. [. . . ] To cancel or to change the previously set time turn programme selector knob to “0” or open the door. After cycle start a default drying time is indicated depending on the selected drying programme. After several minutes the time will be adjusted to the real expected remaining time, depending on size, type and humidity of the load. Synthetics Synthetics - Remaining time indication Delicate Anti-Crease Protection 30’ 20’ 1. 5 1. 5 kg Filter Re-distributes laundry in the drum. When the Anti-Crease option is selected and laundry has not been taken out, an anti-crease cycle is activated for 12 hrs. During the count-down the drum will turn from time to time to redistribute the laundry. The indicator lamp lights up when the filter needs cleaning. Clean the filter at the end of every cycle. Airing - - - Airing Laundry is aired and refreshed for 30 minutes without heating. PROGRAMME SEQUENCE INDICATORS Lit: Drying is running. Drying Cool Down/ Airing End Anti-Crease Lit: Airing is running. Lit: Anti-Crease is running. Completes drying or dries single items (suitable for all fabrics). Time * Test programmes according IEC 61121. 5019 307 00122 PREPARING THE LAUNDRY 1. Check that all fastenings are closed and that pockets are empty. Place laundry loosely in the drum to make sure it doesn’t become tangled. Sort laundry as follows: A) By care symbols (on the collar or inside seam): Suitable for tumble drying Tumble drying with reduced drying intensity only Do not tumble dry B) By amount and thickness/weight Whenever the load to be dried exceeds dryer capacity, separate laundry according to weight (e. g. The Start/Pause indicator lamp is blinking “ “. To operate the new programme, press the Start/ Pause “ “ button again. INTERRUPTING A PROGRAMME To interrupt the dryer during operation 1. Set the programme selector knob to Airing “ “. Wait at least 5 minutes before opening the door to allow the dryer to cool down. For your safety the programme stops automatically if you open the door. To restart, after door opening, close the door and press theStart/Pause “ “ button again. DAILY MAINTENANCE & CLEANING Clean the lint filter at the end of every drying cycle: 1. Remove lint using a soft brush or your fingertips. TROUBLESHOOTING GUIDE If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • Was the correct programme selected?• Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm)? [. . . ] • Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm)?• Is the lint filter dirty (filter indicator lamp on)?The dryer does not operate: (after a power failure and/or interruption to the mains supply, always press the Start button). • Is the plug properly inserted into the mains electricity socket? [. . . ]