User manual WHIRLPOOL AWZ 3796 INSTRUCTION FOR USE

[. . . ] Installation • Do not install your dryer where it can be subject to extreme conditions, such as: poor ventilation, temperatures around freezing (or above 35°C). • Remove the protective foil from the control panel. • Level the dryer by adjusting the two front feet. • Take care not to trap the mains cable between the dryer and the wall. [. . . ] Stacking kit Your dryer can be stacked on top of your front loading washing machine. To do this, use stacking kit AMH 542, available from your dealer. Minimum Width: Height: Depth: housing dimensions: 600 mm 850 mm 560 mm 10 PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing The packing box may be fully recycled as confirmed by the recycling symbol. Energy saving tips • Always dry a full load: depending on the type of laundry and the programme/drying time. • Always use the maximum allowed spin speed of your washing machine. You will save time and energy when running your drying cycle. • Clean the lint filter after every drying cycle. • Place your dryer in a room with a temperature between 15° C and 20° C. In case of higher temperature ventilate the room. • Always select the correct programme/drying time for the load in order to obtain the desired drying results. Note: If the vent hose is not supplied, the AMH 577 kit, available from your dealer, should be used. Installing the vent hose 1. Place a towel or the packing material on the right-hand side next to the dryer. Place the dryer on its right-hand side (seen from the front) on the towel or the packing material. Push the adapter into the hose (see illustration). Attach the adapter with the vent hose to the connection in the dryer base and lock it into place. Venting outside • Without kinking it, lead the vent hose outside (inside diameter 10 cm, maximum length with two bends 3 m). • Ensure that the vent hose does not sag when stacking the dryer on a washing machine. It should only be placed horizontally or upwards. • Do not connect to ventilation systems protected by fly nets. These can become clogged and cause malfunctioning of the dryer. • Do not connect the vent hose to a chimney system. [. . . ] • Do not connect the vent hose to a chimney system. • Do not connect the vent hose to the heating system. Only connect the hose to ventilation systems insulated against humidity. Dryer operation without vent hose • Only use the dryer in a large, well-ventilated room. [. . . ]