User manual WHIRLPOOL AWZ 510 D WP PROGRAM CHART

[. . . ] This programme (40°C) is tested and approved by The Woolmark Company for handwashable wool. Curtains and delicate clothing in wool or silk only washable in cold water. Outer clothing worn for short periods and made of cotton, polyester, polyamide and cotton blends. Slightly to normally soiled garments made of cotton and/or synthetics. [. . . ] • After pressing the “Start”, the number of hours preselected can be reduced by pressing and holding the “Start Delay” button. To cancel the “Start Delay”: Press the “Start delay” button until the time indicated on the display is “00”; the selected programme will then start. PROGRAMME START Open the tap and press the “Start”. The indicator next to the “Start” button lights up. “DOOR OPEN” INDICATOR At the end of a programme, the message “End” appears on the display, indicating that the door can be opened. As long as a wash programme is running, the door remains locked and must not be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. DISPLAY ALPHANUMERIC INDICATIONS E02-E03 “Service” The display of this “Service” code can be due to a faulty electrical component. Refer to the “Troubleshooting guide” in the Instructions for Use; If the fault persists, contact the After-Sales Service. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. In domestic use, consumption data may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The time indicated on the display (if present) can deviate from the values in the table, because it takes into account the household * conditions applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference programme for energy label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in the Instructions for Use. Turn the programme selector to the desired programme. The indicator of the predefined spin speed lights up; in case you want to set another spin speed, press the “Variable spin” button. SELECT ANY DESIRED OPTION Press the button(s) of any required option(s) - the respective indicator lights up. When the combination of programme and additional option(s) is not possible, the indicators switch off automatically. Unsuitable combinations of options are deselected automatically. “Prewash” button • Only for heavily soiled loads (e. g. • Do not use liquid detergent for the main wash when activating the prewash option. “Intensive rinse” button • More water is added and the rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen, and helps people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without the final spin cycle, to avoid creasing and prevent colours from changing. [. . . ] Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. CHANGING PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Turn the programme selector to “Off/O”. [. . . ]