User manual WHIRLPOOL AWZ 512 PROGRAM CHART

[. . . ] made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Curtains and delicate clothing, skirts, shirts and blouses. Only woollens labelled with the Woolmark and identified as machine washable. This programme (40°C) is tested and approved by The Woolmark Company for handwashable wool. [. . . ] The indicator next to the “Start” button lights up. The programme sequence indicator shows the current programme stage, running from left to right through Prewash/Wash, Rinse, Spin/Drain, End. “DOOR OPEN” INDICATOR At the end of a programme, the “End” indicator lights up signalling that the door can be opened. As long as a wash programme is running, the door remains locked and must not be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATORS “Service” indicator Lighting up of the “Service” indicator can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in the Instructions for Use; If the fault persists, contact our After-Sales Service. “Clean pump” indicator The water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the filter”). “Water tap closed” indicator Machine water supply insufficient or lacking. Open the water tap; Turn the programme selector to “Off/O” and reset the programme. If the indicator remains on, refer to the “Troubleshooting Guide” in the Instructions for Use. “Door open” indicator Lighting up of the indicator could be caused by the door not being properly closed. Turn the programme selector to “Off/O” and reset the programme. If the indicator remains on, refer to the “Troubleshooting Guide” in the Instructions for Use. PROGRAMME END • Lighting up of the lamp on the wash sequence indicator means that the programme has ended and the door is unlocked. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. CHANGING PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. [. . . ] SELECT ANY DESIRED OPTION Press the button(s) of any required option(s) - the respective indicator lights up. When the combination of programme and additional option(s) is not possible, the indicators switch off automatically. Unsuitable combinations of options are deselected automatically. “Prewash” button • Only for heavily soiled loads (e. g. [. . . ]