User manual WHIRLPOOL AWZ 566 INSTRUCTION FOR USE

[. . . ] GB TABLE OF CONTENTS PAGE DESCRIPTION OF THE DRYER FILTER WATER CONTAINER BEFORE USING THE DRYER PRECAUTIONS PREPARING THE LAUNDRY SELECTING DRYING TIME OR PROGRAMME AND OPTIONS STARTING AND COMPLETING THE PROGRAMME INSTALLATION ELECTRICAL CONNECTION DRAINAGE SYSTEM DOOR REVERSIBILITY MAINTENANCE TROUBLE SHOOTING GUIDE AFTER-SALES SERVICE 13 13 13 14 14 15 16 17 18 18 20 20 20 21 21 PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE To get full satisfaction from your dryer, please read carefully your instruction manual. 12 DESCRIPTION OF THE DRYER 1. Work-top Condensation water container Contact pin Door (Door opening can be reversed). See “Door reversibility” section. To close the door: push the door gently until it closes. [. . . ] Select the drying time and the options according to the table (see Programme Table). Options (if available) To select an option, press the corresponding button. Press the button again to cancel the option. The Start delay selector should be turned clockwise to the required time delay and the Start button pressed. It is possible to select a delay from 1 to 8 hours. The time delay can be changed at any time by simply turning the Start delay selector. The remaining time to the programme start is shown on the selector. Close the door and press the Start button again to continue the count-down. To cancel the countdown turn delay selector to “0”. Gentle Reduces the drying temperature for delicate articles. Buzzer Pressing the button initiates a buzzer sound to signal at regular intervals, at the end of the drying cycle. Additional Programme Airing The laundry will be aired during 20 minutes without heating. STARTING AND COMPLETING THE PROGRAMME 1. Having selected the desired drying time or programme and options, press the Start button. If selected a buzzer sounds to signal the end of the drying cycle. It will sound at regular intervals for some time. If you do not unload the laundry at the end of the drying cycle, an automatic anti-crease cycle will operate for maximum 20 min. (Electronic dryer): the drum rotates at regular intervals preventing the laundry from creasing. On completion of the programme, set the programme selector knob to position “0”. The “Machine On” light goes off. Clean the lint filter and empty the water container at the end of each drying cycle. If you change the programme (electronic dryer) during the drying cycle the dryer stops. To operate the new programme press the Start button again. 17 Interruption of the drying cycle To interrupt the dryer during the drying cycle, set the programme selector knob to position ( ) Airing and press the Start button again for the Electronic dryer. [. . . ] Remove the pipe in the lower part behind the dryer and mount it to the plastic connector (shown in driagram), put a rag underneath to collect water spillage. Connect the pipe supplied with the dryer to the connector. • Was the inserted laundry too humid (Washing machine spin speed less than 800 rpm)?• Is the lint filter dirty (filter indicator light on)? [. . . ]