User manual WHIRLPOOL AWZ 660 PROGRAM CHART

[. . . ] Clean the filter at the end of every cycle. - - - - Lights up when water container needs to be emptied. The drying Water Container cycle is automatically interrupted. Press the Start/Pause button to restart the dryer and to continue the programme. PROGRAMME SEQUENCE INDICATORS Drying The programme sequence Airing indicator lamps show the status or the progress of the drying cycle. [. . . ] • Press the option button again to cancel the option. FILTER Clean the lint filter at the end of every drying cycle: 1. Remove lint using a soft brush or your fingertips. Push the filter firmly back into place. WATER CONTAINER BOTTOM Empty the water container at the end of every drying cycle. Pull the handle to remove the water container. Replace the water container when empty by pushing it completely back in place. STARTING AND COMPLETING A PROGRAMME 1. Having selected the desired programme and options, press the Start/Pause button. If the laundry is not removed at the end of the drying cycle, an automatic anti-crease cycle will operate for maximum 60 min. The drum rotates at regular intervals, preventing the laundry from creasing for 12 hours if the option anti-crease has been selected. On completion of the programme, set the programme selector knob to position “0”. The dryer indicator lamp “Start/Pause” switches off. INSTALLATION STABILITY When installing your dryer, always carefully level the dryer by means of the adjustable feet and check the correct levelling with a spirit level. The dryer does not operate: (after a power failure and/or interruption to the mains supply, always press the Start/Pause button). • Is the plug properly inserted into the mains electricity socket?• Has the Start/Pause button been pressed?Lint filter or water container indicator lamp light on: • Is the lint filter clean?• Is the water container correctly positioned?Water droplets underneath the dryer: • Is the heat exchanger correctly positioned?• Has any fluff on the heat exchanger seal been wiped away?• Has any fluff on the door seal been wiped away?• Has the water container been positioned correctly? AFTER-SALES SERVICE If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call our After-Sales Service (refer to guarantee). Please specify: • The nature of the fault. • The service code (the number after the word Service on the adhesive rating plate) on the righthand side when the door is open. [. . . ] Slot vertical: the door cannot be locked. Slot horizontal: the door can be locked. TROUBLESHOOTING GUIDE If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • Was the correct programme selected?• Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm?When the spinning speed is less than 800 rpm the water container fault may occur during the drying cycle. )? [. . . ]