User manual WHIRLPOOL AWZ 7303

[. . . ] Do not use extension leads or multiple adaptors. Before any maintenance on the dryer disconnect it from the mains supply. Do not operate the dryer if it has been damaged during transport. Contact one of our After-Sales Service technicians. [. . . ] In case of higher temperature ventilate the room. Always select the correct programme/drying time for the load in order to obtain the desired drying results. Select the gentle option only with small loads. dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting. Disposing of packaging and old Dryer: The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. Child safety: Children must not be allowed to play with the dryer. EC Declaration of Conformity This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: 73/23/EEC Low Voltage Directive 89/336/EEC EMC Directive 93/68/EEC CE Marking Directive. The dryer must only be used in the household for the prescribed uses. 13 DESCRIPTION OF THE DRYER A. Door: To open the door: pull the handle. To close the door: push gently until closed. Heat exchanger. A B2 G C F E D H B1 Reminder - Maintenance and Cleaning Clean the lint filter at the end of every drying cycle. Open the door Pull the filter upwards Open the filter Remove lint using a soft brush or your fingertips Close the filter Push the filter back into place. Heat exchanger Clean the heat exchanger at least every 3 months (See "HEAT EXCHANGER" chapter). Wipe away any lint/fluff from the door seal and interior using a damp cloth. 14 DRAINAGE SYSTEM For water container top only To avoid having to empty the water container at the end of each cycle, the condensation water can be drained away. Note: Normally the drain hose is not supplied; the accessory AMH 883 kit, available at your dealer or our After Sales Service, should be used. The connection for direct draining is at the rear of the dryer. A. Place an absorbent cloth underneath to collect water spillage. Remove the hose located at the lower rear part of the dryer and insert it in the nearby hole. Fix the hose (length: 1. 5 m) to the outlet connection. The height difference between the two drainage connections should not exceed 1m. Notice: To avoid siphoning, the end of the hose must not be immersed in the drain water. Avoid bending and twisting the hose. B C 15 DOOR REVERSIBILITY / CHILD SAFETY LOCK Door Reversibility A. [. . . ] Lint filter or water container indicator lamp light on: Is the lint filter clean? Is the water container correctly positioned?Water droplets underneath the dryer: Is the heat exchanger correctly positioned? Has any fluff on the heat exchanger seal been wiped away? [. . . ]