User manual WHIRLPOOL AWZ 7915 INSTRUCTION FOR USE

[. . . ] The indicator lamp lights up when a humidity controlled program is selected, Overdry protection to indicate the working protection function. Function is not active in time controlled programs and Airing . PROGRAMME SEQUENCE INDICATORS Lit: Overdry protection is working Overdry Protection Drying Blinking: programme selected; cycle need to be started. [. . . ] Crease Start Pause * Test programmes according IEC 61121. Time Airing Synthetics 5019 307 00233 PREPARING THE LAUNDRY 1. Check that all fastenings are closed and that pockets are empty. Place laundry loosely in the drum to make sure it doesn’t become tangled. Sort laundry as follows: A) By care symbols (on the collar or inside seam): Suitable for tumble drying Tumble drying with reduced drying intensity only. Do not tumble dry B) By amount and thickness/weight Whenever the load to be dried exceeds dryer capacity, separate laundry according to weight (e. g. C) By type of fabrics Cotton/linen: Towels, cotton jersey, bed and table linen made of cotton or linen. Synthetics/Easy Care: blouses, shirts, overalls, etc. made of polyester or polyamide, as well as cotton/synthetic mixes. D) By drying level • Sort into: iron dry, cupboard dry, etc. Set the programme selector knob to Airing “ “. Wait at least 5 minutes before opening the door to allow the dryer to cool down. For your safety the programme stops automatically if you open the door. To restart, after door opening, close the door and press the Start/Pause button again. DAILY MAINTENANCE & CLEANING Clean the lint filter at the end of every drying cycle: 1. Remove lint using a soft brush or your fingertips. TROUBLESHOOTING GUIDE If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • Was the correct programme selected?• Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm)?• Is the lint filter dirty (filter indicator lamp on)?The dryer does not operate: (after a power failure and/or interruption to the mains supply, always press the Start button). [. . . ] The dryer does not operate: (after a power failure and/or interruption to the mains supply, always press the Start button). • Is the plug properly inserted into the mains electricity socket?• Has the Start/Pause button been pressed? [. . . ]