User manual WHIRLPOOL AWZ 8000 PRO INSTALLATION

[. . . ] CONTENTS QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET DEFINITION OF USE INSTALLATION TRANSPORT AND HANDLING DESCRIPTION OF THE DRYER VENT CONNECTION DOOR REVERSIBILITY SETUP THE DRYER ELECTRICAL CONNECTION SAFETY ADVICES GENERAL RECOMMENDATIONS GENERAL INFORMATION / DISPOSAL MAINTENANCE AND CLEANING AFTER-SALES SERVICE Page Page Page Page Page Page Page Page Page Page Page Page Page 12 12 13 13 14 15 16 17 18 19 19 20 20 11 DEFINITION OF USE • The dryer is exclusively destined to dry dryable laundry in quantities which are recommended in the PROGRAMME CHART. • Observe the instructions given in this instruction for use and the programme chart before using the dryer. • Keep the instruction for use and the programme chart. If you pass on the dryer to another person, also give him/ her the instructions for use and the programme chart. [. . . ] These can become clogged and cause malfunctioning of the dryer. Using a spanner, turn the contact pin (C) in the upper part of the door through 90° and pull it out. C D. Removing the 2 door hinge screws, followed by the door. Unscrew the 2 screws above and below the door lock system. Removing the door lock: using a screwdriver, press down on the small rib in the upper opening and extract the door lock by pulling it towards you. Fasten the door on the desired side using the 2 screws. Insert the door lock system on the opposite and lock it securely. Fix the 2 screws above and below the door lock system. Replace the contact pin in the inside of the door (top). D NOTE: Use for the unscrewing a screw driver of the type “Torx T20”. E F E 15 SETUP THE DRYER • For security reason do not remove the worktop. • Connect the dryer to an external ventilation system in order to prevent steam from damaging your furniture during the years. Stacking kit Depending on the model of your washing machine, your dyer can be stacked on top of your front loading washing machine. For further information please contact the After-Sales-Service. Minimum housing dimensions: Width: 600 mm Height: 855 mm Depth: 560 mm Sound level • Sound pressure level, LPA < 70 dB(A) (Kpa: +/-2, 5 dB(A) 16 ELECTRICAL CONNECTION 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A. S. T. A. approved fuse to BS 1362 type and proceed as follows: 1. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost, the plug must not be used until a correct replacement is fitted. Correct replacements are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. 2) For the Republic of Ireland only The information given in respect of Greeat Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. 3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instruction. Please do not attempt to change the plug yourself. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufacturer’s instructions and current standard safety regulations. 17 SAFETY ADVICES To minimize the risk of fire in a tumble dryer, the following should be observed. • • Oil-affected item can ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. [. . . ] This prevents the dryer from being switched on accidentally. • Before cleaning or carrying out maintenance switch off the dryer and disconnect it from the mains supply. • To clean the outside of the dryer, use a neutral detergent and a damp cloth. • The final phase of a drying cycle always occurs without heat (cool down phase) to ensure that the items are left at a temperature that ensures that the items will not be damaged. [. . . ]