User manual WHIRLPOOL AWZ 8593 INSTRUCTION FOR USE

[. . . ] Brush lint using a soft brush or your fingertips. Close the filter and push it back into housing until it clicks. Filter Indicator light (if available) It warns that the filter is dirty and needs to be cleaned. If the laundry is insufficiently dry, check that the filter is not clogged. BEFORE USING THE DRYER • After unpacking please make sure that the dryer is undamaged. In case of doubt do not use the dryer but call a qualified technician or your retailer. [. . . ] Options (if available) To select an option, press the corresponding button. Press the button again to cancel the option. The Start delay selector should be turned clockwise to the required time delay and the Start button pressed. It is possible to select a delay from 1 to 8 hours. The time delay can be changed at any time by simply turning the Start delay selector. The remaining time to the programme chart is shown on the selector. Close the door and press the Start button again to continue the count-down. To cancel the count-down turn Start delay selector to “0”. Suitable for delicate articles. Buzzer Pressing the button initiates a buzzer sound to signal at regular intervals, at the end of the drying cycle. Additional Programme Airing The laundry will be aired during 20 minutes without heating. STARTING AND COMPLETING THE PROGRAMME 1. Having selected the desired drying time or programme and options, press the Start button. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol 4 or coloured green or green and yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured red. Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A. S. T. A. approved fuse to BS 1362 type and proceed as follows: 1. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. For the Republic of Ireland only The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. In this case, the wire which is coloured GREEN AND YELLOW must be connected to the EARTH contact, and the two wires to the two pins, irrespective of colour. The supply to the socket must be fitted with a 16 amp fuse. Connection to a rewirable plug If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere. A suitable alternative plug should then be fitted to the cable. 41 VENT CONNECTION When delivered from the factory the vent hose with an adaptor is in the drum. Vent hose mounting 1. [. . . ] NB: When vent hose is not supplied it is recommended to use the kit AMH 577 which is available from your dealer. DOOR REVERSIBILITY To change the direction of opening of the door 1. Remove the contact pin at the upper part of the door with a spanner. Turn the contact pin 90° and take it out. Unscrew the 2 screws at the door hinge and remove the door. [. . . ]