User manual WHIRLPOOL AWZ 8595 INSTRUCTION FOR USE

[. . . ] • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. • Remove the protective foil from the control panel. Electrical Connections • Electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions and current standard safety regulations. • Electrical connection must comply with local Electricity Board regulations. [. . . ] • • • • • • • • • 14 The packing box may be fully recycled as confirmed by the recycling symbol . Energy saving tips Always dry a full load: depending on the type of laundry and the programme/drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. You will save time and energy when running your drying cycle. Clean the lint filter after every drying cycle. Place your dryer in a room with a temperature between 15° C and 20° C. In case of higher temperature ventilate the room. Always select the correct programme/drying time for the load in order to obtain the desired drying results. Select the gentle option only with small loads. dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting. Remove lint using a soft brush or your fingertips. • Empty the water container at the end of each drying cycle. EACH MONTH • Clean the heat exchanger at least every month (see “HEAT EXCHANGER” chapter). Wipe away any lint/fluff from the door seal and interior using a damp cloth. Remove fibres in and around the water evacuation hole (at least once per month). 15 DRAINAGE SYSTEM For water container top only To avoid having to empty the water container at the end of each cycle, the condensation water can be drained away. Note: normally the drain hose is not supplied; the accessory kit, available at your dealer or our After-Sales Service should be used. Please contact your dealer or our After-Sales Service to get the reference of this accessory, which should be used. The connection for direct draining is at the rear of the dryer. A. Place an absorbent cloth underneath to collect water spillage. Remove the hose located at the lower rear part of the dryer and insert it in the nearby hole. Fix the hose (length: 1. 5 m) to the outlet connection. [. . . ] Slot vertical: the door cannot be locked. Slot horizontal: the door can be locked. E I E 17 HEAT EXCHANGER Before cleaning or carrying out maintenance, switch off the dryer. Clean the heat exchanger at least every month, proceeding as follows: A. Open the door and press the heat exchanger flap button on the bottom of the door entrance. [. . . ]