User manual WHIRLPOOL AWZ 8888 INSTRUCTION FOR USE

[. . . ] Brush lint using a soft brush or your fingertips. Push it back into housing until it clicks. Filter Indicator light (if available) It warns that the filter is dirty and needs to be cleaned. If the laundry is insufficiently dry, check that the filter is not clogged. BEFORE USING THE DRYER • After unpacking please make sure that the dryer is undamaged. In case of doubt do not use the dryer but call a qualified technician or your retailer. [. . . ] Press the button again to cancel the option. The start delay selector should be turned clockwise to the required time delay and the Start button pressed. It is possible to select a delay from 1 to 8 hours. The time delay can be changed at any time by simply turning the start delay selector. The remaining time to the programme chart is shown on the selector. Close the door and press the Start button again to continue the count-down. To cancel the count-down turn start delay selector to “0”. Suitable for delicate articles. Buzzer Pressing the button initiates a buzzer sound to signal at regular intervals, at the end of the drying cycle. Additional Programme Airing The laundry will be aired during 20 minutes without heating. STARTING AND COMPLETING THE PROGRAMME 1. Having selected the desired drying time or programme and options, press the Start button. If selected a buzzer sounds to signal the end of the drying cycle. Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a socket. 2 pin with side earth contact) The wire which is coloured GREEN AND YELLOW must be connected to the earth contact. The other two wires should be connected to the two pins, irrespective of colour. 3) FUSE REPLACEMENT If the mains lead of this appliance is fitted with a BS 1363A 13 amp fused plug, replace the fuse only with an A. S. T. A. approved type conforming to BS 1362 and proceed as follows: 2) CONNECTION TO A REWIRABLE PLUG - to be carried out only by a qualified electrician The wires in the mains lead are coloured in accordance with the following code: BLUE - “NEUTRAL” (“N”) BROWN - “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) To fit a new plug, proceed as follows: 2. 1 Polarized Plugs (e. g. 3 pin, 13 amp plug conforming to BS 1363A) a. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol or coloured yellow or green and yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured red. Remove the fuse cover (A) and the fuse (B). Fit the replacement 13 A fuse into the fuse cover. For all other types of plug, the supply socket should be protected by a 16 A fuse or circuit breaker at the distribution board. 17 VENT CONNECTION When delivered from the factory the vent hose with an adaptor is in the drum. [. . . ] • The minimum distance from the air opening to the wall must be at least 10 cm. DOOR REVERSIBILITY To change the direction of opening of the door 1. Remove the contact pin at the upper part of the door with a spanner. Turn the contact pin 90° and take it out. Unscrew the 2 screws at the door hinge and remove the door. [. . . ]