User manual WHIRLPOOL AWZ EXPERT CI INSTRUCTION FOR USE

[. . . ] Do not use extension leads or multiple adaptors. Before any maintenance on the dryer disconnect it from the mains supply. Do not operate the dryer if it has been damaged during transport. [. . . ] The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. • Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. Child safety: Children must not be allowed to play with the dryer. General recommendations: • Always set the programme/time selector knob to the “0” position after use. This prevents the dryer from being switched on accidentally. • Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. • To clean the outside of the dryer, use a neutral detergent and a damp cloth. • Wipe away lint from the door seal and the door using a damp cloth. 12 • • If the lint filter mesh is clogged, clean it with water and a soft brush. Since lint can go through the filter it is necessary to clean, from time to time, the complete filter area (including below the filter) with a brush, a damp cloth or with a vacuum cleaner. If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. EC Declaration of Conformity This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 93/68/EC. • The dryer must only be used in the household for the prescribed uses. DESCRIPTION OF THE DRYER 1. Door: To open the door: pull the handle. To close the door: push gently until closed. Drum light (if available): Only comes on when the door is open (the programme/time has to be selected). Light Off: set the programme/time selector knob to “0” position, or press the option button. [. . . ] Open the door and press the heat exchanger flap button on the bottom of the door entrance. Fold the heat exchanger handle upwards to the horizontal position and remove the heat exchanger. Clean the heat exchanger under running water. [. . . ]