User manual WHIRLPOOL AWZ MAGIC E INSTRUCTION FOR USE

[. . . ] • Before any maintenance on the dryer disconnect it from the mains supply. • Do not operate the dryer if it has been damaged during transport. Contact one of our After-Sales Service technicians. • Mains cable replacement is only to be carried out by After-Sales Service. [. . . ] • Always select the correct programme/drying time for the load in order to obtain the desired drying results. • Select the gentle option only with small loads. • When drying cotton, for example: dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting. Disposing of packaging and old appliances. The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. • Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. Child safety: Children must not be allowed to play with the dryer. General recommendations: • Always set the programme/time selector knob to the “0” position after use. This prevents the dryer from being switched on accidentally. • Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. • To clean the outside of the dryer, use a neutral detergent and a damp cloth. • Wipe away lint from the door seal and the door using a damp cloth. • If the lint filter mesh is clogged, clean it with water and a soft brush. 11 • If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. EC Declaration of Conformity This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 93/68/EC. • The dryer must only be used in the household for the prescribed uses. DESCRIPTION OF THE DRYER 1. Door To open the door: pull the handle To close the door: push gently until closed. Filter 1 2 4 3 VENT CONNECTION On delivery from the factory, the outlet vent hose, together with an adaptor, is located in the drum. Note: If the vent hose is not supplied, the AMH 577 kit, available from your dealer, should be used. Installing the vent hose 1. [. . . ] A minimum distance of 10 cm between rear of appliance and the wall must be observed. 12 DOOR REVERSIBILITY Door Reversibility 1. Using a spanner, turn the contact pin on the inside of the door (top) through 90° and remove it. Remove the 2 door hinge screws, followed by the door. Unscrew the 2 screws above and below the door lock system. [. . . ]