User manual WHIRLPOOL AZA-HP 7572 PROGRAM CHART

[. . . ] A fast blinking lamp indicates a wrong selection is made (incompatible options). Press the button again to cancel the option. The drying programme is started by pressing the “Start (Pause)” button. Changing programme selection: If the programme selected is changed during drying, the dryer stops. [. . . ] Laundry with thick, multi-layered areas such as: bed and table linen, track suits, anoraks, blankets. Laundry which does not require ironing such as: shirts, blouses, T-shirts, sportsware. Laundry which requires ironing such as: trousers, dresses, skirts, shirts, blouses. 3. 5 kg Cotton or linen hot wash / coloured laundry Fabrics Schonen Options Trocken+ Startvorwahl Pause Very wet load Approximate drying times (in minutes) Wet load X X X Max. 7. 0 kg X X X X X X X X X X X X X X X X X X X X X 190 165 155 135 80 65 55 140 125 110 90 70 60 50 Cotton W X Synthetic, mixed fibre or cotton easy care (ironing not required) laundry VW Extra dry Cupboard dry* Iron dry X X X Special V programmes Synthetic Mixed load T-shirts, blouses, towels, underwear, sportswear. Cotton – synthetic blend 3. 5 kg X X X X 130 100 Airing Laundry is aired, refreshed and loosen up for 30 minutes without heating. All textiles. – – – – – Drying items Completes drying (suitable for all fabrics) 30' 60' 90' 120' 150' X X X 30' 60' 90' 120' 150' *Test programmes according to EN61121, tested with maximum rated load capacity. 2 HOW TO PROCEED IF… . . . you want to check the dryer yourself first: (If your machine is not functioning correctly, please check the following points before calling the customer service – also refer to relevant chapter in the Instructions for use) Drying takes too long / Laundry is not dry enough • Has the correct drying programme been selected?• Has the cycle been interrupted (door opening, full water container)?• Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?• Is the lint filter dirty (filter indicator light on)?• Is the heat exchanger dirty (for more information, refer to the Instructions for use)?• Is the room temperature too high?• Is the “End” and “Anticrease” indicator lamp lighting up?The drying cycle is complete and the laundry can be taken out. • If the drying result does not meet your expectation, select a more dry programme or use the dryness adjustment option (if available) to optimize the drying result. • • • • • • • • • • • • Is the plug properly inserted into the mains electricity socket?Has the “Start (Pause)” button been pressed?Has the start delay option been selected?Has the water container been inserted correctly?Is the heat exchanger clean and inserted correctly? The dryer does not operate (after a power failure, always press the “Start (Pause)” button) Filter, water container indicator lamp on Water droplets underneath the dryer • Has the heat exchanger been inserted correctly?• Have all lint on the heat exchanger seal and the door seal been wiped away?• Has the water container been inserted correctly?• If the direct drain connection is used, is it tight?• Is the dryer leveled? . . . you want to care of and clean your dryer: Clean the filter at the end of every cycle • Brush lint using a soft brush or your fingertips. [. . . ] The drying cycle is automatically interrupted. Empty the container and restart the drying programme. Empty the water container after every drying cycle End The drying programme is finished. Please unload the dryer. Delays the start of the drying cycle by 3, 6 or 9 hours. [. . . ]