User manual WHIRLPOOL AZA-HP 8671 PROGRAM CHART

[. . . ] The indicator lamp above the relevant button lights up to confirm your selection. A fast blinking led indicates a wrong selection is made (incompatible options). Press the button again to cancel the option. The drying programme is started by pressing the “Start (Pause)” button. [. . . ] 8 kg Iron dry * Extra dry Cupboard dry * Iron dry X X X X X X X 140 100 X X X X X X X 6 6 — — — — — — — — — Completes drying (suitable for all fabrics). X X X X X X X 30’ 40’ 60’ 90’ * Test programmes according to EN 61121, tested with maximum rated load capacity. HOW TO PROCEED IF. . . . . . you want to check the dryer yourself first: (If your machine is not functioning correctly, please check the following points before calling the customer service - also refer to relevant chapter in the instructions for use) • Has the correct drying programme been selected?• Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?• Is the door filter dirty (filter indicator light on)?• Is the bottom filter dirty (for more information, refer to the instructions for use)?• Is the room temperature too high?• Are the “End” and “Anticrease” indicator lamps lighting up?The drying cycle is complete and the laundry can be taken out. • If the drying result does not meet your expectation, select a drier programme. You can use the dryness adjustment option (if available) to optimize the drying results. • • • • • • • • • • • • • • • • • Is the plug properly inserted into the mains electricity socket?Has the “Start (Pause)” button been pressed?Has the start delay option been selected?Has the water container been inserted correctly?Is the bottom filter clean and inserted correctly?Has the bottom filter been inserted correctly?Have all lint on the bottom filter seal and the door seal been wiped away?Has the water container been inserted correctly?If the direct drain connection is used, is it tight?Is the dryer levelled? Drying takes too long/ Laundry is not dry enough The dryer does not operate (after a power failure, always press the “Start (Pause)” button) Door filter, water container or bottom filter indicator lamp on Water droplets underneath the dryer . . . you want to care of and clean your dryer: • Brush lint using a soft brush or your fingertips. • Pull the handle to remove the water container. • Replace the water container when empty by pushing it completely back in place. • Clean the bottom filter under running water. [. . . ] 5 Water container The indicator lamp lights up when the water container needs to be emptied. The drying cycle is automatically interrupted. Empty the container and restart the drying program. Empty the water container after every drying cycle. Gentle Selecting this option will reduce the drying temperature at the end of the drying cycle and thus the thermal strain on delicate laundry. [. . . ]