User manual WHIRLPOOL AZA9321

[. . . ] To switch the dryer on again turn the programme selector knob to “Off” (“0”) and afterwards to the desired programme. Select the option required by pressing the corresponding button. The indicator lamp above the relevant button lights up to confirm your selection. A fast blinking lamp indicates a wrong selection is made (incompatible options). [. . . ] Sleeping bags, trousers, vests X X – – X X X X X X X X X X – – X X X X X X X X X X X X X X X X 70 65 – 120 50 50 60 120 Silk Wool finish Down Laundry is aired, refreshed and loosen up for 30 minutes without heating. All textiles. Fraîcheur Temps séchage 10’ – 180’ – – – – X X X – – – Drying times Completes drying (suitable for all fabrics) – X X – X X X X 10’ – 180’ *Test programmes according to EN61121, tested with maximum rated load capacity. 2 HOW TO PROCEED IF… . . . you want to check the dryer yourself first: (If your machine is not functioning correctly, please check the following points before calling the customer service – also refer to relevant chapter in the Instructions for use) Drying takes too long / Laundry is not dry enough · Has the correct drying programme been selected?· Has the cycle been interrupted (door opening, full water container)?· Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?· Is the door filter dirty (filter indicator light on)?· Is the bottom filter dirty (for more information, refer to the Instructions for use)?· Is the room temperature too high?· Is the “End” and “Anticrease” indicator lamp lighting up?The drying cycle is complete and the laundry can be taken out. · If the drying result does not meet your expectation, select a more dry programme or use the dryness adjustment option (if available) to optimize the drying result. Is the plug properly inserted into the mains electricity socket?Has the “Start (Pause)” button been pressed shortly after a programme is selected?(If not, the dryer will switch off. ) · Has the start delay option been selected?à Please remove a part of the load. · · · · Is the door filter clean?Has the water container been inserted correctly?Is the bottom filter clean and inserted correctly?· · · · · · The dryer does not operate (after a power failure, always press the “Start (Pause)” button) Door filter, water container or bottom filter indicator lamp on Water droplets underneath the dryer · Has the bottom filter been inserted correctly?· Have all lint on the heat exchanger seal and the door seal been wiped away?· Has the water container been inserted correctly?· If the direct drain connection is used, is it tight?· Is the dryer leveled? . . . you want to care of and clean your dryer: Clean the filter at the end of every cycle · Brush lint using a soft brush or your fingertips. · Push the filter back into place. [. . . ] To deactivate this option, press the button until the “key” symbol disappears. The key lock function is still active even when the selector knob is turned to “off” position or the door is opened. The function has to be deactivated. · Sometimes the programme may finish before the selected “Finish in” time has expired (e. g. In this case, the dryer will tumble the laundry regularly to keep it fresh, until the selected “Finish in” time has expired. [. . . ]