User manual WHIRLPOOL AZB 7570 PROGRAM CHART

[. . . ] The indicator lamp above the relevant button lights up to confirm your selection. A fast blinking LED indicates that an invalid selection has been made (incompatible option). Press the button again to cancel the option. Start the drying programme by pressing the “Start (Pause)” button. [. . . ] Laundry which requires ironing such as: bed and table linen, dry towels, T-shirts, polo shirts, work clothes. Laundry with thick, multi-layered areas such as: bed and table linen, track suits, anoraks, blankets. Laundry which does not require ironing such as: shirts, blouses, T-shirts, sportswear. Laundry which requires ironing such as: trousers, dresses, skirts, shirts, blouses. Iron dry ** Extra dry Synthetic, mixed fibre or cotton easy care (ironing not required) laundry X X X X X X X X X 35’ 80’ 25’ 55’ 20’ 45’ 25’ 60’ 20’ 40’ 15’ 35’ Cupboard dry ** Iron dry Laundry made from synthetic fibres Delicate plus Low drying intensity for delicates and items such as: trousers, dresses, shirts, blouses. Max. 2. 5 kg Cotton - Synthetic blend 2. 5 X X X 85’ 70’ Mixed load T-shirts, blouses, towels, underwear, sportswear. Max. 3 kg 3. 0 X X X 80’ 60’ Laundry is aired, refreshed and loosen up All textiles. All fabrics — — X — — — 20’ 30’ 40’ 60’ Additional drying time for textiles that are not suitable for other programmes, or for finalisation of the drying process. — X X — 20’ 30’ 40’ 60’ How to proceed if. . . . . . you want to check the dryer yourself first: (If your machine is not functioning correctly, please check the following points before calling the Customer Service department - also refer to relevant section in the Instructions For Use). • Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?(filter indicator light on) • Is the heat exchanger dirty?(for more information, refer to the Instructions For Use) • Is the room temperature too high? Drying takes too long/ Laundry is not dry enough • Are the “End” and “Anti-crease” indicator lamps lighting up?The drying cycle is complete and the laundry can be taken out. • If the drying result does not meet your expectation, select a drier programme or use the dryness adjustment option (if available). • Are thin and thick laundry mixed?Sort the laundry by thickness and material, then dry it again. • Is the plug properly inserted into the mains electricity socket?• Is there a power failure? The dryer does not operate (after a power failure, always press the “Start (Pause)” button) • Has the fuse blown?• Has a drying programme been selected?• Has the “Start (Pause)” button been pressed?• Has the start delay option been selected?Please remove some of the load. Lint filter, water container or heat exchanger indicator lamp on • Is the lint filter clean?• Has the water container been inserted correctly?• Is the heat exchanger clean and inserted correctly?• Has the heat exchanger been inserted correctly? [. . . ] Each time the button is pressed the delay is increased by 3 hours. Press the “Start (Pause)” button to confirm the final selection and to start the dryer. The LEDs above the programme selector knob flash to indicate the selected time. During the countdown, the drum will turn from time to time to redistribute the laundry and the pump will start to pump water in the water container. [. . . ]