User manual WHIRLPOOL AZB 8680 PROGRAM CHART

[. . . ] The indicator lamp above the relevant button lights up to confirm your selection. A fast blinking LED indicates that an invalid selection has been made (incompatible option). Press the button again to cancel the option. Start the drying programme by pressing the “Start (Pause)” button. [. . . ] (filter indicator light on) • Is the heat exchanger dirty?(for more information, refer to the Instructions For Use) • Is the room temperature too high? Drying takes too long/ Laundry is not dry enough • Are the “End” and “Anti-crease” indicator lamps lighting up?The drying cycle is complete and the laundry can be taken out. • If the drying result does not meet your expectation, select a drier programme or use the dryness adjustment option (if available). • Are thin and thick laundry mixed?Sort the laundry by thickness and material, then dry it again. • Is the plug properly inserted into the mains electricity socket?• Is there a power failure? The dryer does not operate (after a power failure, always press the “Start (Pause)” button) • Has the fuse blown?• Has a drying programme been selected?• Has the “Start (Pause)” button been pressed?• Has the start delay option been selected?Please remove some of the load. Lint filter, water container or heat exchanger indicator lamp on • Is the lint filter clean?• Has the water container been inserted correctly?• Is the heat exchanger clean and inserted correctly?• Has the heat exchanger been inserted correctly?• Has all lint on the heat exchanger seal and the door seal been wiped away?• Has the water container been inserted correctly?• If the direct drain connection is used, is it tight?• Is the dryer levelled? Water droplets underneath the dryer . . . you want to care for and clean your dryer: • Brush lint using a soft brush or your fingertips. • Pull the handle to remove the water container. • Replace the empty water container by pushing it fully back into place. • Clean the heat exchanger under running water. [. . . ] The drying cycle is automatically interrupted. Empty the container and restart the drying programme. Empty the water container after every drying cycle. Overdry protection / 6th Sense The indicator lights up when a humidity controlled programme is selected, to indicate the activated protection function. Dryness level By selecting this option you can adjust the dryness level of the laundry. The function must be deactivated manually. Dry time adjustment Turn the programme selector knob to the “Time” position. [. . . ]