User manual WHIRLPOOL AZB8220

[. . . ] To switch the dryer on again turn the programme selector knob to “Off” (“0”) and afterwards to the desired programme. Select the option required by pressing the corresponding button. The indicator lamp above the relevant button lights up to confirm your selection. A fast blinking lamp indicates a wrong selection is made (incompatible options). [. . . ] · Has the cycle been interrupted (door opening, full water container)?· Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?· Is the lint filter dirty (filter indicator light on)?· Is the heat exchanger dirty (for more information, refer to the Instructions for use)?· Is the room temperature too high?· Is the “End” and “Anticrease” indicator lamp lighting up?The drying cycle is complete and the laundry can be taken out. · If the drying result does not meet your expectation, select a more dry programme or use the dryness adjustment option (if available) to optimize the drying result. Sort the laundry after thickness and material and dry again. Is the plug properly inserted into the mains electricity socket?Has the “Start (Pause)” button been pressed shortly after a programme is selected?(If not, the dryer will switch off. ) · Has the start delay option been selected?à Please remove a part of the load. · · · · Is the lint filter clean?Has the water container been inserted correctly?Is the heat exchanger clean and inserted correctly?· · · · · · The dryer does not operate Filter, water container indicator lamp on Water droplets underneath the dryer · Has the heat exchanger been inserted correctly?· Have all lint on the heat exchanger seal and the door seal been wiped away?· Has the water container been inserted correctly?· If the direct drain connection is used, is it tight?· Is the dryer leveled? . . . you want to care of and clean your dryer: Clean the filter at the end of every cycle · Brush lint using a soft brush or your fingertips. · Push the filter back into place. [. . . ] Please unload the dryer. Clean heat exchanger The Led lights up after 30 cycles when the heat exchanger needs to be cleaned. Clean the heat exchanger. Dry plus By selecting this option you can increase the dryness level of the laundry. “Remaining time” display Depending on the programme selected a default drying time is displayed. After start of cycle the time displayed is corrected depending on the volume, type and moisture of the laundry. The drying time specified is a calculated value which will be updated during the drying cycle. [. . . ]