User manual WHIRLPOOL BEM 510S INSTALLATION

[. . . ] Important safety instructions Read carefully and keep for future reference • Do not heat, or use flammable liquids in or near the appliance. fumes can create a fire hazard or explosion. € Do not leave the appliance unattended • Do not use corrosive chemicals or vapors in this appliance. This type of appliance is specifically designed to heat water. [. . . ] Dip the cappuccino maker into the milk for about 5 mm and turn the steam knob anticlockwise, taking care not to immerse the raised line on the cappuccino maker (indicated by the arrow). The ESE standard is a system accepted by leading pod producers and enables espresso coffee to be prepared simply and cleanly. Place the small filter (1 cup or pods) in the filter holder, making sure the projection is correctly inserted in the slot. Insert a pod, centring it as far as possible on ENGLISH 10 Turn the steam knob at least a half turn anticlockwise. Steam is discharged from the cappuccino maker, giving the milk a creamy frothy appearance. To obtain a creamier froth, dip the cappuccino maker into the milk and rotate the container with slow movements from the bottom upwards. When the required temperature is reached (60°C is ideal), interrupt steam delivery by rotating the steam knob clockwise and at the same time pressing the steam button. Discharge a little steam for a few seconds by rotating the steam knob. This empties any milk left inside the steam spout. IMPORTANT: To ensure hygiene, you are recommended to follow this procedure each time you make cappuccino to avoid milk stagnating in the milk circuit. With one hand, hold the cappuccino tube firmly and with the other unscrew the cappuccino maker itself by rotating clockwise and extracting downwards. € Clean the inside of the filter holder. € Unscrew the cap of the frother by turning anticlockwise. € Remove the frother from the container by pushing it from the cap end. Rinse all components and clean the metal filter thoroughly in hot water using a brush. € Replace the filter and gasket on the plastic disk. Make sure to insert the pin on the plastic disk into the hole in the gasket indicated by the arrow. € Replace the assembly in the steel filter container, making sure the pin is inserted in the hole in the support. € Finally, screw on the cap by turning clockwise. Failure to clean as described above invalidates the guarantee. Make sure the holes in the metal filter are not blocked. Cleaning the boiler outlet About every 300 coffees, the espresso boiler outlet must be cleaned as follows. [. . . ] € Non-functional and decorative parts which do not affect normal use of the appliance, including any scratches and possible color differences. • Accidental damage caused by foreign objects or substances and cleaning or unblocking of filters , drainage systems or soap drawers. € Damage to the following parts: ceramic glass, accessories, crockery and cutlery baskets, feed and drainage pipes, seals, lamps and lamp covers, screens, knobs, casings and parts of casings. Unless such damages can be proved to have been caused by production faults. [. . . ]