User manual WHIRLPOOL BLZH 4006 WS PROGRAM CHART

[. . . ] Detergents and Additives Special options Max. Spin Speed rpm 700 700 700 700 700 700 700 700 – 2) 700 700 700 700 – Programme Main Softener Bleach BiIntensive Rinse wash speed Rinse Hold 700 Rinçage Arrêt cuve 400 intensif pleine Yes Yes Yes Yes Yes Yes Yes Yes Yes – – – – – i i i i i i i i i i i – – – i – – i – – – – – – – – – – i i i i i i i i i i i i i – i i – i i i – – – i i – – – i i i i i i i i i i i – – – Cotton with prewash Synthetic with prewash Delicate with prewash Cotton 95º - 60º - 40º Daily Mixed Synthetic 40° Delicate 40° Wool 40° Silk 30° Rinse + Gentle Spin Rinse + Spin Spin Gentle Spin Drain Prélavage Coton Prélavage Synth. Prélavage Délicat Coton 95° - 60° - 40° Heavily soiled bed linen, table linen and underwear, towels, shirts etc. Heavily soiled blouses, shirts, overalls etc. [. . . ] Programme to spin cotton or linen laundry intensively with maximum spin speed. Programme to spin delicate laundry gently with a restricted spin speed. Alternative method of terminating programme after „Rinse Hold“. N. B. Please avoid excessive detergent dosing. 5019 612 10102 CONSUMPTION DATA Temperature Selector (°C) 95 60 40 40 60 40 40 40 30 Load (kg) 5, 0 5, 0 5, 0 3, 0 2, 0 2, 0 1, 5 1, 0 1, 0 Water (l) 63* 59 59 49 56 56 60 60 60 Energy (kWh) 1, 80 0, 95 0, 55 0, 48 0, 80 0, 45 0, 55 0, 50 0, 30 Approx. Programme Duration (hours : minutes) 2:05 2:05 2:05 1:00 1:30 1:20 0:45 0:40 0:50 Programme Cotton Cotton Cotton Daily Mixed Synthetic Synthetic Delicate Wool Silk Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard EN/IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60°C”. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. “Rinse Hold” button (Arrêt cuve pleine) • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading. • This option is particularly recommended for the “Synthetic”, “Delicate” and “Daily Mixed” programmes. • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Note: The programme selector knob stops on . Appliance in “Rinse Hold”: • Pres s the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle. • If you do not wish to spin the clothes, press the “On/Off” button, turn the programme selector knob to the “Drain” programme and press the “On/Off” button again. PROGRAMME START Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. END OF WASH CYCLE • The programme selector knob is in the Stop position. Press the “On/Off” button to switch off the machine. Wait for the lid to unlock (about 1 minute). Open the lid and the drun doors and unload the machine. [. . . ] Turn the programme selector knob to the desired programme. SELECT THE DESIRED OPTION Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Bi-speed” button • Press button to set the spin speed. Note: every programme has an automatic maximum spin speed. [. . . ]