User manual WHIRLPOOL BSZ 5000 WS INSTRUCTION FOR USE

[. . . ] • The oven must be repaired or adjusted only by a qualified technician. • Make sure that the electrical wires of other electrical appliances near the oven do not come into contact with hot parts and do not become entrapped in the oven door. • Use oven gloves to remove baking trays and accessories when the oven is hot. • Do not cover the bottom of the oven with aluminium foil. [. . . ] • Check that the appliance has not been damaged in transit. • Oven dimensions and kitchen unit dimensions are shown in the opposite figure. • Kitchen units in contact with the oven must be heat resistant (80°C min). • Install the oven in the housing, lifting it at the sides, taking care not to trap the wires of the electrical supply cable. • For correct ventilation, follow the ventilation opening directions shown in the figure (500 min x 80 mm and 500 min x 50 mm inside the cabinet). • Secure the oven to the kitchen unit with screws (A) as shown. • The oven has also been designed for building-in under a cooktop. Installation NOTE: To allow for proper ventilation, we recommend that you left an opening of at least 500 x 80 mm or an equivalent area in the lower section of the housing. An additional opening of 5 mm is required between the oven top rim and the cooktop lower rim: this opening must not be closed by strips or housing crosspieces. During oven installation, care must be taken to ensure that the sides are not touching the front edges of the housing or adjacent drawers and doors (see picture). No Contacts Electrical connection • Warning: Do not connect to the power supply before you have finished connecting the oven. • Make sure the oven is installed and connected to the electricity supply by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. • The installer is responsible for the correct electrical connection of the oven and the observance of the relative safety regulations. • The oven must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. • Do not use multiple plug adapters or extension leads. • After the oven has been installed, the electrical components must be inaccessible. • Make sure that the voltage shown on the rating plate is the same as the power supply voltage in your home. The rating plate is on the front edge of the oven cavity (visible with oven door open). Oven accessories Drip tray The drip tray is designed to collect fat and food particles when it is positioned under the grid; it can also be used as a griddle to cook meat, Accessories supplied depend on the model (refer to the Product Description Sheet supplied separately) chicken and fish, with or without vegetables. When using the drip tray under the grid, pour in a little water to avoid fat spatters and smoke. Baking tray For cooking biscuits, meringues and pizzas. Grid The grid can be used to grill food or as a support for baking trays, cake tins and other cooking receptacles. Catalytic panels (depending on model) The catalytic panels have a microporous coating that absorbs fat spatters. We recommend an automatic cleaning cycle after cooking particular fatty food. It can be placed on any of the shelves in the oven. 1. To clean the oven heat it to 200°C when empty and leave it switched on for about an hour. 2. At the end of the cycle and when the oven is cool, use a moist sponge to remove food residues if necessary. Do not use detergent or cleaners - risk of damaging the catalytic enamel coating. Spit (depending on model) Use the spit as indicated in the relevant chapter in the Product Description Sheet supplied separately. [. . . ] 1. To clean the oven roof, pull out the grill element and lower it as far as it will go. 2. Clean the oven roof and then return the grill element to its original position. Changing the oven lamp 1. Disconnect the oven from electrical supply. Changing the lateral lamp (depending on model) 1. Disconnect the oven from electrical supply. 3. Use a screwdriver to prize off the lamp cover. [. . . ]