User manual WHIRLPOOL BSZ 5900 SW INSTALLATION

[. . . ] The oven must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. Do not use multiple plug adapters or extension leads. After the oven has been installed, the electrical components must be inaccessible. Make sure that the voltage shown on the rating plate is the same as the power supply voltage in your home. [. . . ] Products • The appliances are built from recyclable materials. If you decide to scrap the appliances act responsibly and observe local waste disposal by laws. Cut off the power cords so that the appliances cannot be connected to the mains. . PRECAUTIONS AND GENERAL RECOMMENDATIONS • Before any maintenance on the oven disconnect it from the electrical power supply. Keep children away from the oven when they are in use. The oven must be repaired or adjusted exclusively by a qualified technician. Make sure that the electrical wires of other electrical appliances near the oven do not come into contact with hot parts and do not become entrapped in the oven door. • • • Use oven gloves to remove baking trays and accessories when the oven is hot. Do not cover the bottom of the oven with aluminium foil. Do not place inflammable material in the oven - risk of fire if the oven is inadvertently switches on. • • • 15 OVEN ACCESSORIES • Accessories supplied depend on the model (refer to the Product Description Sheet supplied separately). 1 1 Drip tray The drip tray is designed to collect fat and food particles when it is positioned under the grid; it can also be used as a griddle to cook meat, chicken and fish, with or without vegetables. When using the drip tray under the grid, pour in a little water to avoid fat spatters and smoke. Baking tray 2 For cooking biscuits, meringues and pizzas. Warning: While you are cleaning the oven, ensure you do not disengage the hinge retainer catches. Refit the oven door by following the above steps in reverse order. Dropping the grill element to clean the oven roof (depending on model) • Do not attempt to clean the oven until it is cool. To clean the oven roof, pull out the grill element and lower it as far as it will go. Clean the oven roof and then return the grill element to its original position. Disconnect the oven from electrical supply. Changing the lateral lamp (depending on model) Disconnect the oven from electrical supply. Use a screwdriver to prize off the lamp cover. Reposition the lamp cover and press it against the oven wall until it clicks into place. N. B: Use exclusively 25 W 230 V lamps, type E-14, T300°C, available from After Sales Service. 5. . TROUBLESHOOTING GUIDE Oven not working • Switch the oven off and then on again to see if the problem persists. [. . . ] Ensure that the mechanical programmer (depending on model) is set to . • 19 AFTER SALES SERVICE Before contacting After Sales Service: 1. Try to solve the problem (see “Troubleshooting Guide”). Turn off the appliance and restart it to see if the fault is repeated. If after the above checks the fault still occurs, get in touch with the nearest After Sales Service. [. . . ]