User manual WHIRLPOOL C 310 BR INSTRUCTION FOR USE

[. . . ] This information remains in the memory even during interruption of the power supply. To change the selected programme, press the Start button for about 5 seconds, until the Start indicator lamp switches off. Select a new programme and press the Start button. Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. [. . . ] To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min. ). Once the Start indicator lamp has switched off, turn the programme selector knob to the initial position to switch off the dishwasher. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. • • Upper and lower rack To raise: pull up the two side handles until the rack clicks into place. Up: plates. Lower rack Crockery holders: • • Upper rack C Cutlery basket: • • The cutlery basket (C) can be removed to increase available space. Some models are provided with a grid (D) that can be fitted onto the cutlery basket. Glass holder: D C Rack height adjustment: (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. • To lower: pull out the two side handles and gently lower the rack. Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. • Is the salt container cap (water softening system) screwed down?Marked crockery: • Is the water hardness level selector not properly adjusted?(See “Filling the salt container” in the user instructions). (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used?(See “Filling the rinse aid dispenser” in the user instructions). Note: with some models, when the Start button is pressed a pre-wash cycle precedes the actual wash programme; this regenerates the water softening system. AFTER-SALES SERVICE If, after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Please specify: • The nature of the fault. • The service code (the number after the word Service on the adhesive rating plate) inside the door on the right-hand side. • • • • Important • • Fill the detergent dispenser and check the salt and rinse aid level. [. . . ] Do not use the appliance for items not suitable for washing in a dishwasher, for example: wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Do not put liquid fat in the dishwasher (e. g. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). [. . . ]