User manual WHIRLPOOL C 313 BR INSTRUCTION FOR USE

[. . . ] Once set, the programmed data cannot be altered by turning the programme selector knob. Note: once the Start button has been pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply. To change the selected programme, press the Start button for about 5 seconds, until the Start indicator lamp switches off. [. . . ] Select a new programme using the programme selector knob and press the Start button. Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min. ). Turn the programme selector knob to the initial position to switch off the dishwasher (only after the Start indicator lamp has switched off). Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. • • Upper and lower rack To lower: pull out the two side handles and gently lower the rack. To raise: pull up the two side handles until the rack clicks into place. Up: plates. Lower rack • Upper rack Crockery holders: • • C Cutlery basket: • • With or without handle (depending on model). Are the spray arms blocked or the nozzles clogged?(See “Care and Maintenance” chapter in the user instructions). Is the lower spray arm correctly fitted?Is the salt container cap (water softening system) screwed down?(See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). (See “Filling the rinse aid dispenser” in the user instructions). • AFTER-SALES SERVICE If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Please specify: • The nature of the fault. • The service code (the number after the word Service on the adhesive rating plate) inside the door on the right-hand side. • • • • • • • Important • • Fill the detergent dispenser and check the salt and rinse aid level. Do not use the appliance for items not suitable for washing in a dishwasher, for example: wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. [. . . ] Do not use the appliance for items not suitable for washing in a dishwasher, for example: wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Do not put liquid fat in the dishwasher (e. g. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). [. . . ]