User manual WHIRLPOOL C 411 INSTRUCTION FOR USE

[. . . ] CONTENTS INSTALLATION INSTRUCTIONS LOCAL REGULATIONS AND REQUIREMENTS BEFORE USING THE APPLIANCE GENERAL PRECAUTIONS AND RECOMMENDATIONS DECLARATION OF CONFORMITY CE CARE AND MAINTENANCE INSTRUCTIONS COOKING HINTS COOKING TABLES INJECTORS TABLES AFTER-SALES SERVICE PAGE PAGE PAGE PAGE PAGE GB 18 23 24 24 24 25 26 27 29 30 PAGE PAGE PAGE PAGE PAGE 17 INSTALLATION INSTRUCTIONS Ventilation of rooms Details of rooms ventilation: see your local specific standards. This cooker is not connected to a device to vent the combustion products. It must thus be installed and connected in conformity with the installation standards in force. Particular attention must be paid to the standards on ventilation of the room. [. . . ] 4 OVEN GAS GRILL Adaptation to different gas types (Fig. 5) This operation is performed inside the oven. Remove the grill retained by screw G and, using a socket wrench, replace injector J with an injector of the type which corresponds to the gas to be used, in accordance with the Injector Table. Air adjustment (Fig. 5) The air/gas mixture is correct when the flame is blue. If the flame tends to spread away from the grill or if it is not sharp, adjust screw H in accordance with the Injector Table. 5 Gas system maintenance For the After-Sales Service: When a knob seizes up and is difficult to turn, never remove the tap bearing: remove and replace the entire tap. 6 and 7 opposite for exact positioning of the oven and grill thermocouples. Fig. 7 21 INSTALLATION INSTRUCTIONS Notes • The appliance must be correctly installed by a qualified technician in accordance with the applicable safety standards. It is essential that this appliance is earthed. The manufacturer cannot accept any liability for personal injury or damage to property resulting from a failure to comply with the above-mentioned standards. Remove the cardboard protections from inside the oven. The sides of furniture or appliances located next to the cooker must be capable of withstanding temperatures which can reach 80°C. Replacing the supply cable To connect the cooker supply cable, proceed as follows (see Fig. 1): • Open the terminal board cover, which is placed on the bottom right rear panel, making pressure on the two tongues. • Remove about 60 mm of the external sheathing from the power supply cable. The earthing wire, which is coloured yellow and green, must be 30 mm longer than the other power cable wires. • Pass the power supply cable into conduit (C) of the terminal board. Connect it to the terminal strip in accordance with the electrical diagram shown below. • Ensure that the “GREEN and YELLOW” wire is connected to the earth terminal (marked by the symbol ). • Fix the cable into the cable clamp, using screws L-N. • Fix the cable into conduit (C) and close the terminal board cover. Note: After the installation, the electrical parts must not be accessible without the use of an appropriate tool. The power supply cable must be of the type H05RR-F, in accordance with the table below. [. . . ] Dissolve any food residues with a specific oven cleaner, then rinse and dry thoroughly. When the oven is cold, clean the outside glass parts. Do not use scouring powder or abrasive pads. N. B. : When removing the oven bottom for cleaning purposes, please make sure that it is properly repositioned with the two arrows at the front side. Catalytic panels (depending on model) The catalytic panels have a microporous coating that absorbs fat spatters. [. . . ]