User manual WHIRLPOOL C 415 INSTRUCTION FOR USE

[. . . ] Remember that this appliance can only be installed and work in well-ventilated rooms, according to the standards in force, such as to allow, with openings on the external walls or with special ducts, correct natural or forced ventilation to ensure permanently and sufficiently both the entry of the air needed for correct combustion and the removal of spent air. Remember that the quantity of air necessary for combustion must never be less than 2 m3/h for each kW of power (see total power in kW on the appliance data plate). The use of a gas cooking appliance results in the production of heat and moisture in the room in which it is installed. Ensure that the kitchen is well ventilated: keep natural ventilation holes open or install a mechanical ventilation device (mechanical extractor hood). [. . . ] 4) It is essential to calibrate the thermostat following adjustment of the air/gas mixture. On completion of this operation, proceed as follows: • Remove the oven bottom. • Fully tighten screw G when use the butane/ propane. • Unscrew screw G by a 1/2 or 3/4 turn for natural gas or for air/butane. • Light the oven burner and set the thermostat to the maximum position. • Close the oven door and wait approximately 15 minutes. • Set the thermostat to position 1 and use screw G to adjust the flame. • Turn to the right to reduce the height of the flame, or to the left to increase the height. The adjustment is correct when the body of the flame is about 2 to 4 mm in height. • Replace the knob and set it to the position to switch off the burner, then replace the oven base. Fig. 4 OVEN GAS GRILL Adaptation to different gas types (Fig. The nominal voltage of the electrical power supply to the dwelling is the same as that of the appliance, as stated on the rating plate which is visible after removal of the drawer. On cookers without drawer the rating plate is placed on the rear side. The power supply line to which the appliance is to be connected is of a sufficient power, relative to the maximum power consumed by the appliance, as stated on the rating plate. The electrical power installation of the dwelling is correctly earthed. POWER SUPPLY VOLTAGE 1N ~ 230V CONDUCTORS NUMBER X DIMENSIONS 3 x 0, 75 mm² ELECTRICAL CONNECTION LN Fig. 1 22 INSTALLATION INSTRUCTIONS Fig. 1 The cooker must be installed as indicated in Fig. In case of installation next to column units exceeding the height of the hob, always leave at least 100 mm between the appliance and the column unit. Fig. 2 The cooker has four feet which can be used to match the height of the kitchen furniture (see Fig. To assemble the feet: • Lift the cooker and position the plastic feet in the relevant seats. LOCAL REGULATIONS AND REQUIREMENTS Installation and Service This appliance shall be installed in accordance with the regulations in force and only in a wellventilated space. Read the instructions before installing or using this appliance. France The installation and maintenance of the appliance must be carried out by a qualified skilled worker in accordance with the regulations and trade rules in force, and in particular: Order of 2 August 1977 modified Technical and Safety Rules applicable to fuel gas and liquefied hydrocarbon installations located within residential buildings and their outbuildings. Standard DTU P 45 - 204 - Gas installation (formerly DTU no. [. . . ] Grease can be removed easily using hot water or a specific product for cleaning enamelled surfaces. Do not leave any acid or alkaline substances (lemon juice, vinegar, salt, etc. ) on the enamel. Clean the parts in stainless steel with specific cleansers for stainless steel surfaces. • Oven light If it is necessary to replace the oven light bulb, switch off the main power supply. Bulb: 15 W / 230 V, type E14, heat-resistant to 300°C. 25 CARE AND MAINTENANCE INSTRUCTIONS Oven Clean the walls of the oven with hot water and soap. [. . . ]