User manual WHIRLPOOL C 435 INSTRUCTION FOR USE

[. . . ] in this programme spinning is intensive. Same as the spin cycle in the “Coloured Cotton” programme. Same as the spin cycle in the “Wool” programme. Softener Main Wash E Detergents and additives Prewash For improved garment care spin speed is restricted to 900 rpm in this programme. [. . . ] In this programme default spin speed can be increased till 400 rpm. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. **To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in the booklet. Turn the programme selector knob to the desired programme. The remaining time display shows the duration of the chosen programme (in hours and minutes) and the pilot lamp of the “Start/Pause” button is flashing. The programme sequence and the predefined spin speed indication corresponding to the selected programme lights up. €¢ If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button again when flashing. “Spin Speed Reduction” button • Every programme has an automatic predefined maximum spin speed. €¢ Press the button to set another spin speed. €¢ If the spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. PROGRAMME START Open the tap and press the “Start/Pause” button. The pilot lamp of the “Start/Pause” button lights up. The indicator lamps show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding lamp goes out. [. . . ] When the sequence of the programme is finished the corresponding lamp goes out. DOOR LOCK The door can be opened when the “Door Open” indication is on. PROGRAMME END • The remaining time is on “0:00” and all the lights of the programme sequence indication are off. Turn the programme selector to the “ ” position. [. . . ]