User manual WHIRLPOOL C 6332 LD WH PRODUCT FICHE

[. . . ] Select the desired programme by turning the selector’s knob clockwise: position 1: “Pre-wash”; position 2: “Intensive”; position 3: “Daily”. The dishwasher starts automatically as soon as the On/Off button has been pressed. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. The wash programme is over when the selector's knob is back in the Stop position. Upper and lower rack Upper rack Lower rack 3. [. . . ] Press the On/Off button to switch the dishwasher on. Switch off the dishwasher now by pressing the On/Off button. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap. Crockery holders: • Down: cups and long-stemmed glasses. • Up: plates. Cutlery basket (A): • The cutlery basket can be either inserted or removed to increase available space, as required. • If present, the central compartment is recommended for storing teaspoons. To change the selected programme, press the On/Off button to turn the dishwasher off and then turn the selector knob to the desired programme. Press the On/Off button to start the newly selected programme. Note: if you switch off the dishwasher during a wash cycle, when switched on again, the dishwasher resumes the cycle from where it was interrupted. Plate holders (B) (if available): Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. Is the salt container cap (water softening system) screwed down?Is the salt dispenser properly adjusted?(See “Filling the salt container” in the user instructions). (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). (See “Filling the rinse aid dispenser” in the user instructions). • Your full address and telephone number. AFTER-SALES SERVICE If, after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Please specify: • The nature of the fault. • The service code (the number indicated after the word Service on the adhesive rating plate) inside the door on the right-hand side. • • • • • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • • • • • Is the plug properly inserted in the wall socket? [. . . ] • The service code (the number indicated after the word Service on the adhesive rating plate) inside the door on the right-hand side. • • • • • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • • • • • Is the plug properly inserted in the wall socket?Is the flow of water obstructed by impurities?If so, close the water supply tap, detach the water hose and clean the filter. Then re-connect the water hose to the tap and open the water tap once again. [. . . ]