User manual WHIRLPOOL CBA 308 NF/AL INSTRUCTION FOR USE

[. . . ] Door reversibility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Energy saving tips . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Electrical Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 1 T Door reversibility The direction of door opening can be changed. How to proceed: Disconnect the appliance from the power supply. Empty the appliance and remove grids and baskets. Remove the plastic protections that cover the fixing holes on the left of the middle hinge and fit the new plastic protections supplied on the opposite side. 4), using a 6 mm pipe wrench and then screw it on the opposite side. Remove the upper pin on the refrigerator door and the support-cover 7 (fig. (Same procedure as for freezer door). 5. Put a protection (cloth, carton) on the floor and place the items on it, so that the doors are not ruined when they are being removed 6. 15 63733036_gb. p65 15 13/06/2002, 10:40 10. Replace the appliance in vertical position and, if necessary, adjust the doors (intermediate and lower hinge adjustment) in order to ensure perfect adherence of seals and correct coupling alignment. Make sure that all the screws have been tightened correctly and check the door seal by placing a sheet of paper between the cover and the seal: the sheet must resist when it is pulled or moved. Switch on the appliance again. V Fig. • Do not select a temperature that is too low. Adjust the thermostat depending on the amount of food stored. Refrigerator compartment Turn the thermostat knob (fig. Leave the appliance to operate at this setting for 24 hours. Then adjust the setting according to your needs. NOTE: the 0 position on the knob switches off the refrigerator compartment. Electrical Connection A 10-16 A socket with earth connection is required. Regulations require that the appliance is earthed. We cannot be considered responsible for accidents caused by the non-observance of this provision. 9 17 63733036_gb. p65 17 13/06/2002, 10:40 Freezer compartment • Position the thermostat knob (fig. 10) to 4. Leave the appliance to operate at this setting Turn the thermostat knob (fig. Leave the appliance to operate at this setting for 24 hours. • Then adjust the setting according to your needs. [. . . ] • Use the multifunction tray 2 (fig. 15) as drain • Rinse with a solution of water and vinegar pan • Dry the walls • Switch on the appliance again and then replace the food. Routine maintenance Prolonged disuse: Disconnect the appliance from the power supply To aerate the compartments of your appliance, wedge the doors open using, for example, corks attached with adhesive tape (fig. 17) Fig. 17 21 63733036_gb. p65 21 13/06/2002, 10:41 What to do if small problems occur? If faults occur whilst using your refrigerator-freezer, please check: Trouble. . . The appliance is not working at all The lamp will not switch on The appliance is excessively noisy Water drips from under the refrigerator There is too much frost build-up in the freezer compartment There is too much frost build-up in the refrigerator compartment and the temperature is too low The temperature inside the freezer is too low The red LED is alight Check. . . - The electrical connections. - The position of the thermostat/s: must not be set to 0. [. . . ]