User manual WHIRLPOOL CBB 35 INSTRUCTION FOR USE

[. . . ] Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safeguarding the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Precautions and general recommendations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Presentation of the refrigerator-freezer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Keep the packaging materials (plastic film, polystyrene parts, etc. ) out of reach of children and do not dispose of in the environment. Choose a well-ventilated place where the ambient temperature is between + 16°C and + 32°C. Observe this warning in order to store your frozen food in good conditions and in compliance with European regulations. Install your appliance away from sources of heat, radiators, oven, cookers, direct and intense sunlight . . . Check the installation location to be sure you have clearance on all sides. 7) on the condenser grill to prevent it from touching the wall. W Fig. Unscrew the lower pin of the refrigerator door 8 (Fig. 6), then fix it on the opposite side, after removing the protection. Put the protection in the original position of the pin support. (Same procedure as for freezer door). X Fig. Position the refrigerator door fitting the upper pin in its support, then fit the middle hinge and screw it on. Proceed as described above for the freezer door and tighten the screws of the lower hinge. Q R Fig. 7 16 63733036_gb. p65 16 13/06/2002, 10:40 Adjust front feet 1 and 2 (fig. 8) so that the appliance is slightly tilted backwards; in this way the door will close properly. To avoid undesired sounds, make sure that the appliance is stable. This appliance is designed to be connected to a 220-240V/50HZ electric system. Before connecting, make sure that the thermostat knob/s is/are turned to “0”. Using the appliance Leave the appliance in vertical position for at least two hours after transport, before switching it on, so that the refrigerant liquid can stabilize. Q R Fig. 8 Switching on appliances with a separate temperature adjustment for each compartment: • A refrigerator thermostat located on the right hand side of the control panel with 7 positions and 0 (STOP) • A freezer thermostat located on the left hand side of the control panel with 4 positions and 0 (STOP) Energy saving tips • To install your appliance follow the instructions in the chapter “Installation”. • Remove dust from the condenser grill on the rear of the appliance once a year in order to allow air to circulate freely around the cooling flaps. • Wait for hot food to cool before placing in the refrigerator. • To defrost products, place them in the refrigerator compartment; they will help cool the food in the refrigerator. • Leave the door open as little as possible when you store or take out food. • Do not select a temperature that is too low. Adjust the thermostat depending on the amount of food stored. Refrigerator compartment Turn the thermostat knob (fig. [. . . ] - That the floor is level - That the levelling feet are adjusted properly - The drain hole is obstructed; eliminate the blockage. - It needs defrosting - The door seal is not airtight, check feet are properly blocked. - That the thermostat knob is not set to a position that is too high: if it is, turn it progressively to a lower position so that the motor has its normal stopping periods again. - That the “fast freeze” button has not been pressed. [. . . ]