User manual WHIRLPOOL CCH 510 OS 220 V PROGRAM CHART

[. . . ] 42009aGB. fm5 Page 1 Sunday, January 2, 2000 2:20 PM PRODUCT SHEET 1. Red LED: Indicates that the freezer temperature is not sufficiently low. 1 3. [. . . ] Frost formation on the upper edges and interior walls of the appliance is a natural phenomenon and will not affect the performance of the freezer. GB F E 42009aGB. fm5 Page 2 Sunday, January 2, 2000 2:20 PM PRODUCT SHEET Switching on the freezer for the first time • • • • It is advisable to set the thermostat to a middle position on the thermostat scale (factory set position). The red LED will also switch on since the temperature inside the freezer is not yet sufficiently low for food storage. The red LED will normally switch off within the first six hours after the appliance is switched on. Only place food inside the freezer once the red LED has switched off. It will prove difficult to open the lid immediately after closing it because the hermetic seal means there is a partial vacuum inside the freezer. Wait a few minutes before re-opening the lid. • • After connecting the appliance to the mains, when the right temperature has been reached (about an hour), ensure that the fast freeze function is inactive (yellow LED is off). Freezer compartment temperature adjustment To adjust the compartment temperature, proceed as follows: • Turn the thermostat knob x to position 1 to set the highest (least cold) storage temperature. • Turn the thermostat knob x to position 6 / to set the lowest (coldest) storage temperature. • When the freezer is only partially full, it is advisable to set the thermostat to lower positions (towards position “E”, if indicated on the thermostat scale). Energy saving tips • • • • • • • Do not install the appliance in places exposed to direct sunlight or near heat sources, since this would lead to increased energy consumption. Do not obstruct the ventilation grille or the air circulation apertures. Remove accumulated dust from the rear of the appliance at least once a year. [. . . ] Unscrew the light bulb and replace it with an identical bulb of the same wattage and voltage. Refit the diffuser and plug in the appliance. 1 2 3 5019 100 42009/A GB F E Printed in Italy 01/00 [. . . ]