User manual WHIRLPOOL CENTURY 1400 PROGRAM CHART

[. . . ] made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. 2. 5 Curtains and delicate clothing, dresses, skirts, shirts and blouses. 2. 0 Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles made of silk, linen, wool and viscose marked as handwashable. This programme is tested and approved by The Woolmark Company for machine- and handwashable wool. [. . . ] Do not use liquid detergent when activating the “Start delay”. • Select programme, temperature and options. • Press the “Start delay” button to select a delay time up to 23 hours. The light of the “Start (Pause)” button blinks. • Press the “Start (Pause)” button . The light of the “Start (Pause)” button is on. The light of the start delay button will keep blinking until the programme starts. • As soon as the programme starts, the start delay on the display is replaced by the remaining programme time, and the light of the “Start delay” button goes off. • Once having pressed the “Start (Pause)” button , the number of hours preselected can be changed by pressing and holding the “Start delay” button. To cancel the “Start delay” . . . before you press “Start (Pause)” : • Turn the programme selector to another position or press the “Reset/Drain” button . . . . after having pressed “Start (Pause)” : • Press “Start (Pause)” - the delay time disappears from the display. Press “Start (Pause)” again to start the selected programme immediately. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Reset a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use. If the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. If the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned. In the latter case refer to the Instructions for Use (“Removing the Filter”). Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. [. . . ] The display shows the remaining programme time. Due to variations in load and temperature of inlet water, the remaining time is newly calculated in certain programme phases. If this is the case, an animation appears on the display. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press “Start (Pause)” light blinks. [. . . ]