User manual WHIRLPOOL CF 35 PRODUCT FICHE

[. . . ] Green LED: Illuminates when the appliance is on. Orange illuminated button: Fast freeze function ON/OFF. [. . . ] The fast freeze function is active when the orange LED in the button is lit. 1 2 3 1 2 3 4 The exact configuration of the controls may vary according to the model. Notes: For correct operation of the appliance and to allow the lid to open freely without damage, leave at least 7 cm clearance at the sides and rear. After installation, wait for at least two hours without moving the appliance before connecting it to the power supply; this will enable the refrigerant circuit to reach optimum efficiency. If the freezer is left empty for short periods, it is preferable not to switch it off. Frost formation on the upper edges and interior walls of the appliance is a natural phenomenon and will not affect the performance of the freezer. GB F E 42009aGB. fm5 Page 2 Sunday, January 2, 2000 2:20 PM PRODUCT SHEET Switching on the freezer for the first time • • • • It is advisable to set the thermostat to a middle position on the thermostat scale (factory set position). Remove accumulated dust from the rear of the appliance at least once a year. Use the thermostat to select the ideal storage temperature. Do not place hot food in the refrigerator. Restrict the number of times you open the lid. Make sure the ice layer does not build up to more than 5-6 mm thick. Changing the lid light bulb • • • • Unplug the appliance. [. . . ] Make sure the ice layer does not build up to more than 5-6 mm thick. Changing the lid light bulb • • • • Unplug the appliance. Remove the diffuser by following the sequence of steps shown in the figure. [. . . ]