User manual WHIRLPOOL CH120 INSTRUCTION FOR USE

[. . . ] Fix the flue support to the wall as close as possible to the ceiling. For filter hoods, at this stage, also secure the deflector F1 with 2 screws if the flue is provided with top grilles (for flues with bottom grilles, see installation step “7”). Hang the hood on the wall again and fix in place with the screws. For filter versions (flues with bottom grilles), the deflector F2 must be fixed in place of the connector collar (model with fixture with 2 screws) or on the connector collar (model with 2 rear couplings and 1 front fixing screw). [. . . ] • On models with electronic control panels, fit the card S3 in the socket alongside the control box S2. • Connect the hood to the mains supply and fix the telescopic flue to the flue bracket with two screws. Slide the bottom section down into its seat on the top of the hood. Fit the side grilles if provided. 5019 618 33114 GB IL * Only present on some models 4 3 3 1 1. Light : move the switch to the right or press the button to switch on. Extraction speed : move the switch to the right or press the next button to increase extraction speed (or open the electric shutter) . Lamp covers (or halogen lamps, depending on the model). Grease filters: a Metal grease filters have an unlimited life and should be washed once a month either by hand or in a dishwasher at a low temperature and with a short cycle. Washing in a dishwasher can cause b grease filters to turn white, but this in no way affects efficiency. Press the handle to release the filter b. Wash the filter and leave it to dry, proceeding in reverse order to refit it. 2 Bulb/s: Remove the filters and remove the burnt-out bulb. Make sure the hood was not damaged during transport. Declaration of conformity PRECAUTIONS AND GENERAL RECOMMENDATIONS IMPORTANT! • The appliance is not intended for use by young children or persons with restricted physical, sensory or mental abilities or without experience and knowledge of the appliance, unless they are under the supervision or instruction of a person responsible for their safety. • Children must be supervised to ensure that they do not play with the appliance. Do not connect the appliance to the mains power supply until installation has been completed. Always disconnect the hood before cleaning or carrying out maintenance by unplugging it or switching off the power supply. Do not “flambé” food under the hood. Do not leave pans unattended when frying. Regular cleaning and maintenance is essential to correct functioning and good performance. Never use flammable materials as hoses for extracted air. If the hood is used together with other appliances powered by gas or other fuels, ambient negative pressure must not exceed 4 Pa (4 x 10-5 bar). For this reason, make sure the room is adequately ventilated. Exhaust air must not be conveyed through the same flue used by the heating system or other appliances powered by gas or other fuels. [. . . ] The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Note: Always wear work gloves for all installation and maintenance operations. This product has been designed, manufactured and sold in conformity to the following standards: - safety objectives of “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE as amended) - protection requirements of the “EMC” Directive 89/336/CEE amended by Directive 93/68/CEE. Troubleshooting guide The hood does not work: • Is the plug properly inserted in the power socket?The hood is not extracting enough: • Is the right speed selected? [. . . ]