User manual WHIRLPOOL CLHB 20 NE PROGRAM CHART

[. . . ] Do not switch on the hotplates/cooking zones when there is no pan in position. Avoid the use of high pressure water or steam cleaning equipment. If liquid spills or boils over, the hob may switch off: to enable it to be switched back on again, carefully dry the controls zone. The cooktop features different size hotplates/cooking zones. [. . . ] The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. The appliances are designed, built and sold in compliance with: safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC and subsequent amendments); the protection requirements of Directive “EMC” 2004/108/EC; the requirements of Directive 93/68/EEC. CLEANING AND MAINTENANCE Clean the cooktop, when it is cool, after each use. This will prevent the build-up of dirt and make cleaning easier. Important: at all costs avoid the use of high pressure water or steam cleaning equipment. • Use a clean cloth, absorbent kitchen wipes and washing up liquid or a specific glass ceramic cleaner. • Remove baked-on dirt with the special scraper tool (if provided) and specific cleaning products. • Food spills should be cleaned off before they bake onto the glass ceramic surface. • Foods with high sugar content (toffee, fruit juice, jam, etc. ) that boil over while cooking, or spattered sugar stains must be immediately removed using a scraper. • Do not use abrasive products, bleach, oven-cleaner spray or pan scourers. The cooktop should be treated periodically with a proprietary brand of protective wax for glass-ceramic hobs. GB2 TROUBLESHOOTING GUIDE Cooktop not working • When pressing the control buttons, did you follow the instructions in the section “Using the hob” in the enclosed “Product Description Sheet”?• Is there perhaps a power failure?• Did you dry the hob carefully after cleaning it?• If a cooking zone has been selected and an F or an ER appear on the display followed by a number, contact the After Sales Service and inform them. With the exception of the message F03 or ER03 that identifies the incorrect cleaning of the controls area. To solve the problem follow the instruction in the “Cleaning and maintenance” paragraph. If the hob does not work following intensive use, the hob internal temperature is too high. Wait a few minutes until the hob cools down. AFTER SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the “Troubleshooting guide“. Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-sales Service. Always specify: • a brief description of the fault; • the type and exact model of the oven; • the service number (number after the word Service on the rating plate), located on the right hand edge of the oven cavity (visible when the oven door is open). [. . . ] 70 mm of the cable sheath from the power supply cable (B). Then insert the power supply cable into the cable clamp and connect the wires to the terminal block as indicated in the connection diagram placed close to the terminal block itself. Secure the power supply cable (B) by means of the cable clamp. • Close the terminal board with the cover (A) securing it with the screw provided. [. . . ]