User manual WHIRLPOOL CVT 5097 PRODUCT FICHE

[. . . ] Wait at least two hours before switching the appliance on in order to ensure the refrigerant circuit is fully efficient. Installation of the appliance and electrical connections must be carried out by a qualified electrician, in accordance with the manufacturer’s instructions and local safety regulations 4. Clean the inside of the appliance before using it. SAFEGUARDING THE ENVIRONMENT 1. Packing The packaging material is entirely recyclable, and marked with the recycling symbol. [. . . ] (°C) From 10 to 32 From 16 to 32 From 18 to 38 From 18 to 43 Amb. (°F) From 50 to 90 From 61 to 90 From 64 to 100 From 64 to 110 • Be careful not to damage the floors when you move the appliance (e. g. • Do not use mechanical, electric or chemical means other than those recommended by the Manufacturer to speed up the defrost process. • Do not damage the refrigerator’s refrigerant circuit pipes. • Do not use or place electrical appliances inside the compartments if they are not of the type expressly authorised by the Manufacturer. • This appliance is not designed for use by young children or the infirm without supervision. • To avoid the risk of children being trapped and therefore suffocating, do not allow them to play or hide inside the appliance. • Power cable modification or replacement must only be carried out by qualified personnel. • Do not use single/multiple adapters or extension cables. • It must be possible to disconnect the appliance from the mains by unplugging it or by means of a two-pole switch fitted upline of the socket. • Ensure that the voltage indicated on the appliance data plate corresponds to the domestic supply voltage • Do not swallow the contents (non-toxic) of the ice packs (if provided). • If food has defrosted even partially, do not re-freeze it. • Avoid, or reduce temperature variations to the minimum. Respect the best-before date on the package. • Always observe the storage information on the package. 17 60302013GB. fm Page 18 Tuesday, March 27, 2007 10:22 AM Removing the baskets • Pull the baskets out fully, then lift them up slightly in order to remove. Drawers (except the bottom drawer), runners and the white grid (if provided) may be removed in order to obtain increased storage space (Fig. 1) Ensure that the load does not exceed the limit (if present) indicated on the side walls of the appliance. 1 Compartment Use this compartment only for making ice cubes and storing ice packs, as shown in Fig. Always observe the storage times given on frozen food packaging. Making ice cubes • Fill the ice cube tray 2/3 full and place it in the special freezer compartment. • Do not use sharp or pointed instruments to detach the tray if it is stuck to the bottom of the freezer. • Bend the ice tray slightly to remove the cubes. Note: The freezer door will not re-open easily immediately after closing (except for models featuring a special valve). Wait a few minutes before opening again in order to allow for compensation of the vacuum created. Fig. [. . . ] • Plug in the appliance once again. Note: for electronic models, first insert the power plug into the mains socket and then press the on/off button to switch on the appliance. For the correct defrosting procedure, refer to the PRODUCT DESCRIPTION SHEET. CARE AND MAINTENANCE Before any cleaning or maintenance operation, unplug the appliance from the mains or disconnect the electrical power supply. For electronic models, first press the on/off button and then unplug the the appliance. [. . . ]