User manual WHIRLPOOL CW 782/2 INSTRUCTION FOR USE

[. . . ] The include a full description of your appliance and useful hints to enable you to achieve the correct performances required to store foods. Remove the fuse cover (A) and fuse (B) 2. Fit replacement 13A fuse into fuse cover 3. IMPORTANT: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. [. . . ] The refrigerator is now ready for use. GB DEFROSTING THE APPLIANCE - If your appliance is not provided with the low temperature compartment, defrosting is automatic. During the defrost cycle water droplets drip along the rear wall, the water is then conveyed to a tray situated on the compressor casing where it evaporates. - If your appliance is provided with the compartment, to keep energy consumption low, we recommend that you periodically remove excessive ice and frost from the inside of the compartment. We suggest you defrost when the layer of frost has attained a 3 mm thickness (Fig. To defrost, proceed as follows: - disconnect the appliance from the mains (Fig. 8); - empty the compartment; - turn the thermostat control knob to position q; - dry defrost water with a sponge or a cloth (Fig. At completion of defrosting, dry the compartment walls, connect the appliance to the mains, turn the thermostat control knob to the position required, referring to chapter "Adjustment of the temperature". Also for this model, the defrosting of the refrigerator compartment is automatic. ADJUSTMENT OF THE TEMPERATURE The thermostat (Fig. 1/A) controls the temperature inside the appliance. Position q indicates that the operation of the appliance is interrupted and the interior light is off. To obtain the best storage of foods, we suggest you adjust the thermostat control knob to an intermediate position. To obtain colder temperatures inside the appliances, turn the thermostat control knob towards the higher settings. Contrarily, should the inside temperature be too cold, turn the thermostat control knob towards settings 2-1. We remind you that internal temperatures are affected by the location of the appliance, the temperature of the surrounding air, the frequency of door opening. The setting of the thermostat may have to be varied to allow for these factors. APPLIANCE WITH LOW TEMPERATURE COMPARTMENT We suggest you defrost when the layer of frost reaches a 3 mm thickness (Fig. To defrost: Ensure that the drip tray is emptied and placed under the drain. It is not necessary to empty the refrigerator compartment. Defrosting can be carried out in two ways: Accelerated defrosting Disconnect the appliance from the mains (Fig. Place a bowl with warm water (50°C approx. ) in the low temperature compartment and leave the refrigerator door open (Fig. When the frost has melted, clean the inside and reconnect the appliance to the mains supply. Normal defrosting Press the button (8) in the centre of the thermostat control knob and close the door. When the frost has melted, the switch will return to its original position and the refrigerator will automatically operate. [. . . ] The temperature in the compartment is not cold enough. Check that: - the door is properly closed; - the thermostat control knob is in the correct position (see chapter "Adjustment of the temperature"); - the appliance is not too close to a heat source; - the air flow is not restricted; - the low temperature compartment is not covered with a thick layer of frost; - the condenser is clean (Fig. The temperature in the compartment is too cold. Check that: - the thermostat control knob and the drip tray (if provided) are in the correct position. [. . . ]