User manual WHIRLPOOL D 720 BR INSTRUCTION FOR USE

[. . . ] Make the appliance inoperable by unplugging it and cutting off the power cable. Follow local waste disposal regulations when scrapping. GENERAL TIPS AND SUGGESTIONS 1. Always disconnect the hood by switching off the electrical power supply before cleaning or carrying out maintenance. Exhaust air must not be conveyed through the same flue used by the heating system or other non-electrical appliances. [. . . ] The paper filter is coloured on one side. This colour should not be visible through the grille holes when the filter is installed. • The metal grease filter has an unlimited life and should be washed once a month by hand or in a dishwasher (60°C) with appropriate detergents. Leave filter to dry, handling it carefully before remounting it. Whenever cleaning or replacing the grease filters, clean all other exposed parts of the hood. Carbon filter (“Air recirculation mode”, see following page) The carbon filter cannot be washed or regenerated. Replace the carbon filter (normal usage) every 6 months (Rectangular carbon filter) every 4 months (Circular carbon filter) Replacing the bulbs 1. Pull out the steam deflector (depending on model). Open the grille or light fixture and remove the grease filter. Remove the burnt-out bulb and replace it with a new one of the same wattage. Close the grille, light fixture or metal grease filter. Cleaning the hood Use a soft cloth with methylated spirits or a mild liquid detergent. Failure to observe the instructions for cleaning the appliance and replacing or washing the filters may cause a fire. TROUBLESHOOTING GUIDE Hood does not work: • Is the electrical power supply switched on?Insufficient suction power: • Did you set the right speed?• Do the filters need to be cleaned or replaced?Light does not work: • Does the bulb need to be replaced?Never try to carry out any repair yourself other than fixing the above-mentioned problems. 9 75004Agb. fm5 Page 10 Tuesday, March 27, 2001 10:55 AM AFTER SALES SERVICE Before calling After Sales Service: 1. Check to see if you can fix the problem yourself (see “Troubleshooting guide”). Switch off the hood for a few minutes and re-start it to see if the problem has cleared itself. If the malfunction persists, call After-Sales Service. [. . . ] If the hood does not have a carbon filter, order one and fit it before use. Check that the switch inside the hood (if fitted) is on position “F” Filter; if not, set it to this position. If the plug is provided, close off the upper exhaust hole. ELECTRICAL CONNECTION Before connecting the hood, make sure the voltage indicated on the rating plate corresponds to the voltage in your home. The plate is located inside the hood behind the grille. [. . . ]