User manual WHIRLPOOL DBR 5812/IN/PT INSTRUCTION FOR USE

[. . . ] Carefully observe the following instructions: • Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer's instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. • The appliance must be disconnected from the power supply before carrying out any installation work. • Regulations require that the appliance is earthed. [. . . ] Remove and clean or change the filter regularly. Before installation also check the minimum distances stated in the manual of the cooker. ELECTRICAL CONNECTION Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information may be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 RR-F 3 x 1. 5 mm) must be carried out by a qualified electrician. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with installation rules. GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. During use To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. SAFEGUARDING THE ENVIRONMENT Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol ( ). To remove the filter pull out the handle. After the filter has been washed and dried, replace following the inverse procedure. REPLACING THE ALOGEN LAMPS WARNING: - Only use 20W MAX - G4 halogen lamps. 1. Disconnect the hood from the electric power supply. Insert the blade of a small flat screwdriver where indicated by the three points, and with a gentle pressure lift the cover from its position. Remove the faulty light bulb and replace with a new one. Replace the cover (spring lock). ACTIVE CARBON FILTER (filter models only): The carbon filter must be washed once a month in the dishwasher at the highest possible temperature using a standard dishwasher detergent. It is recommended that nothing else is placed in the dishwasher when washing the filter. After washing, the carbon filter must be reactivated by placing it in the oven at a temperature of 100°C for 10 minutes. Replace the carbon filter every 3 years. Fitting the carbon filter: 1. Remove the filter holding frame by turning the "g" knobs 90°. [. . . ] The hood should be installed away from particularly dirty areas, windows, doors and heat sources. The hood is sold with all necessary components for installation on most types of walls or ceilings. However, ask a qualified technician to check that the items supplied are suitable for the type of wall/ceiling. INSTALLATION SIZES Side cabinets 900 mm min Side cabinets central line 65 cm (gas or mixed cookers) 50 cm (electric cookers) hob surface GB13 INSTALLATION - ASSEMBLY INSTRUCTIONS Before starting the installation procedure remove the perimeter suction panels from the hood, the grease filter and the carbon filter holding frame (if installed) Do this following the procedure below: a. Firmly pull the panel (FRONT SIDE) downwards. [. . . ]