User manual WHIRLPOOL DBR 5890/IN/01 INSTRUCTION FOR USE

[. . . ] Il tubo di scarico e le fascette di fissaggio (15) non sono fornite e vanno acquistate a parte. GR ??????????????. 13 G F 2x 2, 9x6, 5 2 x 3, 5x9, 5 17a 17a 1 11 11 17b H 17b G 12 18 8 4-13 8 16 15 3 2 65 10 B 9 7 6 5 9 14 14 10 7 SAFEGUARDING THE ENVIRONMENT 1. Packing The packing materials are 100% recyclable and are marked with the recycling symbol . Comply with local regulations for disposal. [. . . ] Never use abrasive substances or alcohol. Before using the hood PRECAUTIONS AND GENERAL RECOMMENDATIONS IMPORTANT! ?The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. To ensure best use of your hood, please read these instructions carefully and keep them for future reference. The packing materials (plastic bags, polystyrene parts, etc. ) are a potential source of danger and must be kept out of the reach of children. Make sure the hood was not damaged during transport. This product has been designed, manufactured and put on the market in conformity with the following: - safety objectives of ?Low Voltage?Directive 2006/95/EC (which replaces 73/23/EEC as amended) - protection requirements of ?EMC?Directive 89/336/EEC amended by Directive 93/68/EEC. Declaration of conformity Troubleshooting guide Children must be supervised so that they do not play with the appliance. Do not connect the appliance to the mains power supply until installation has been completed. Always disconnect the hood before any cleaning or maintenance, by unplugging it or turning off the main switch in the home. Do not leave pans unattended when frying, since the cooking oil could catch fire. Regular cleaning and maintenance is essential for correct hood operation and good performance. Depending on the exhaust pipe purchased, provide for suitable fixing to the coupling ring. Important: If already installed, remove the carbon filter/s. Filter version Air is filtered through a carbon filter/s and recycled into the surrounding environment. Important: Ensure that air recirculation is facilitated (carefully follow the instructions given in the installation handbook) Important!If the hood does not have a carbon filter/s, it/they must be ordered and fitted before use. The hood is provided with hardware (e. g. screws and/ or plugs) suitable for most walls/ceilings. However, it is necessary to contact a qualified technician to ensure suitability according to the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Very heavy product; hood handling and installation must be carried out by at least two persons. Remove the perimeter extraction panel and the grease filter/s. Mark a line on the wall up to the ceiling, corresponding to the centre line. [. . . ] Apply the flues and fix them to the flue support G (17b) with 2 screws (17a). Slide the bottom section of the flue to completely cover the extraction unit, inserting it in the special seat above the hood. INSTALLATION - ASSEMBLY INSTRUCTIONS D GB F NL E P I GR Description of hood Fig. 1 1. B. Maintenance ALWAYS disconnect the hood from the power supply. Once a month wash the grease filter and the carbon filter in a dishwasher at the highest temperature, using a normal dishwasher detergent. [. . . ]