User manual WHIRLPOOL DBR 6990/01 IN PT INSTRUCTION FOR USE

[. . . ] IMPORTANT SAFETY INSTRUCTIONS YOUR SAFETY AND THAT OF OTHERS IS PARAMOUNT This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the attention symbol and the following terms: DANGER: WARNING: indicates a hazardous situation which, if not avoided, will cause serious injury. indicates a hazardous situation which, if not avoided, could cause serious injury. All safety warnings give specific details of the potential danger/warning present and indicate how to reduce risk of injury, damage and electric shock resulting from improper use of the appliance. Carefully observe the following instructions: • Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer's instructions and local safety regulations. [. . . ] - By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. GB11 TROUBLESHOOTING GUIDE The appliance does not work: • Check for the presence of mains electrical power and if the appliance is connected to the electrical supply. • Turn off the appliance and restart it to see if the fault persists. The hood's suction level is not sufficient: • Check the suction speed and adjust as necessary: • Check that the filters are clean: • Check the air vents for any obstructions; The light does not work; • Check the light bulb and replace if necessary; • Check that the light bulb has been correctly fitted; AFTER-SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-sales Service. Always specify: • a brief description of the fault; • the exact type and model of the appliance; • the service number (number after the word Service on the rating plate), located on the inside of the appliance. The service number is also indicated on the guarantee booklet; • your full address; • your telephone number. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). CLEANING WARNING: - Never use steam cleaning equipment. - Disconnect the appliance from the power supply. IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. Finish off with a dry cloth. IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. Over time, these can ruin the enamel surface. • Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. GB12 MAINTENANCE WARNING: - Use safety gloves. - Disconnect the appliance from the power supply. GREASE FILTERS The metal grease filter has unlimited duration. It should be washed at least once a month, either by hand, or by placing it in the dishwasher (use a short cycle and low temperature). If washed in the dishwasher, the grease filter surface may become matt. This will not cause any reduction of performance. To remove the filter pull out the handle. After the filter has been washed and dried, replace following the inverse procedure. REPLACING THE ALOGEN LAMPS WARNING: - Only use 20W MAX - G4 halogen lamps. 1. [. . . ] Check the operation of the hood following the instructions in the hood utilisation section. GB15 18a G Ø 2, 9X6, 5 Ø 2, 9X6, 5 18a H F 18b 12 G 11 Ø8 18b 12 Ø 5X45 11 Ø 3x9 (*) 1 15 17 16 (*) 8 8 (*) 4-13 6 5 5 6 B 56 4-13 Ø 5X45 Ø8 2 3 Ø8 10 9 7 10 Ø 5X45 14 Ø8 Ø 5X45 14 9 7 19c 19c 19a 19b GB16 USING THE HOOD 1. Grease filter (above the perimeter suction filter). Control panel To select the functions of the hood simply touch the controls. These are engraved in the centre of the glass on the front of the hood. Off key (stand by) - Exclusion of electronic controls MOTOR OFF Press quickly to switch the motor off. [. . . ]