User manual WHIRLPOOL DBR 6990/IN/PT INSTRUCTION FOR USE

[. . . ] • When drilling through the wall pay attention not to damage electric connections and/or pipes: • Air vents must always discharge to the outside. • The manufacturer rejects all responsibilities for any damage caused by improper use or wrong settings. • Appropriate maintenance and cleaning ensure the good working order and the best performance of the appliance. Regularly clean all stubborn surface dirt to avoid grease build up. [. . . ] Power cable replacement (type H05 RR-F 3 x 1. 5 mm) must be carried out by a qualified electrician. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with installation rules. GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. During use To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. SAFEGUARDING THE ENVIRONMENT Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol ( ). The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. - GB10 TROUBLESHOOTING GUIDE The appliance does not work: • Check for the presence of mains electrical power and if the appliance is connected to the electrical supply. Remove the faulty light bulb and replace with a new one. Replace the cover (spring lock). ACTIVE CARBON FILTER (filter models only): The carbon filter must be washed once a month in the dishwasher at the highest possible temperature using a standard dishwasher detergent. It is recommended that nothing else is placed in the dishwasher when washing the filter. After washing, the carbon filter must be reactivated by placing it in the oven at a temperature of 100°C for 10 minutes. Replace the carbon filter every 3 years. Fitting the carbon filter: 1. Remove the filter holding frame by turning the "g" knobs 90°. Fit the "i" carbon filter inside the filter holder "h". To refit the filter holder and the grease filter follow the inverse procedure. GB12 ITEMS SUPPLIED Remove all components from their packaged. • Assembled hood with motor, light bulbs and grease filters installed. • 1 Chimney support bracket • 1 Hood support bracket • Assembly and user instructions • 1 installation template • 1 - Torx T10 adapter • 1 - Torx T20 adapter • 1 deflector • 6 Ø 8mm wall plugs • 6 Ø 5x45 screws • 2 Ø 2. 9x6. 5 screws • 2 Ø 3x9 screws INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS The hood has been designed to be installed and used either as a "Suction Model", or as a "Filter Model". Suction model Cooking steam is sucked and channelled outside the house through a discharge duct (not supplied), fitted to the hood steam outlet. [. . . ] The small cut at the centre must correspond with the mid line drawn on the wall (operation 1). Drill 2 holes (Ø 8 mm) and insert the 2 wall plugs. Secure the hood to the wall in its final position, with the 2 screws. Connect the cooking steam discharge tube to the fitting ring B. [. . . ]