User manual WHIRLPOOL DBRI 5810/IN/PT INSTRUCTION FOR USE

[. . . ] Slå inte på strömmen till fläktkåpan förrän installationen är helt avslutad. VARNING: Kontrollera att rökrör och rörklämmor medföljer vid leverans av apparaten. Annars måste de köpas separat. Anmärkning: Delar märkta med symbolen “(*)” är extrautrustning som emdast levereras med vissa modeller eller som kan köpas separat. [. . . ] For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. Do not “flambé” food under the hood. The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All the national regulations on air discharge envisaged by art. 7. 12. 1 of CEI EN 60335-2-31 must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. Do not leave pans unattended when frying, since the cooking oil could catch fire. • Do the filters need cleaning or replacing?If the lamp does not work: • Does the lamp need replacing?• Is the lamp correctly fitted? 5019 318 33312 S N DK FIN GB INSTALLATION - ASSEMBLY INSTRUCTIONS The hood is designed for use in “Extractor version” or in “Filter version” Extractor Version fumes are extracted and expelled to the outside through a fumes exhaust hose (not supplied) fixed to the collar of the hood. In accordance with the exhaust hose purchased, provide a suitable fixing system to secure it to the collar. Important: If already installed, remove the carbon filter/s. Filter Version Air is filtered through the carbon filter/s and recycled into the surrounding environment. Important: check that air recirculation is facilitated (to this end, carefully follow the instructions given in the installation handbook) Important!If the hood does not have a carbon filter/s, order one/them and fit it/them before use. Preliminary information for installing the hood: Disconnect the power supply at the domestic main switch before carrying out electrical connections. Expansion plugs are provided to secure the hood to most types of ceilings. However, a qualified technician is needed to make sure that the plugs are suitable for your ceiling. [. . . ] When the acoustic signal is activated, a tone is emitted and the symbol “Snd” appears on the display for 2 seconds. When the acoustic signal is disactivated, the symbol “Snd” appears on the display for 2 seconds but no sound is emitted. Temperature alarm The hood is equipped with a temperature sensor that activates the motor at speed 2 if the ambient temperature around the display area exceeds 70° C (the system monitors the temperature read by the sensor every 250 ms). If the motor is switched OFF or is operating at speed 1 and the temperature alarm is tripped, the motor switches to speed 2 and the display shows “care”. [. . . ]