User manual WHIRLPOOL DBRI 6910/01 IN PT INSTRUCTION FOR USE

[. . . ] IMPORTANT SAFETY INSTRUCTIONS YOUR SAFETY AND THAT OF OTHERS IS PARAMOUNT This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the attention symbol and the following terms: DANGER: WARNING: indicates a hazardous situation which, if not avoided, will cause serious injury. indicates a hazardous situation which, if not avoided, could cause serious injury. All safety warnings give specific details of the potential danger/warning present and indicate how to reduce risk of injury, damage and electric shock resulting from improper use of the appliance. Carefully observe the following instructions: • Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer's instructions and local safety regulations. [. . . ] If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. Finish off with a dry cloth. IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. Over time, these can ruin the enamel surface. • Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. GB14 MAINTENANCE WARNING: Use safety gloves. Disconnect the appliance from the power supply. GREASE FILTERS The metal grease filter has unlimited duration. It should be washed at least once a month, either by hand, or by placing it in the dishwasher (use a short cycle and low temperature). If washed in the dishwasher, the grease filter surface may become matt. This will not cause any reduction of performance. To remove the filter pull out the handle. After the filter has been washed and dried, replace following the inverse procedure. REPLACING THE ALOGEN LAMPS WARNING: - Only use 20W MAX - G4 halogen lamps. 1. Disconnect the hood from the electric power supply. Insert the blade of a small flat screwdriver where indicated by the three points, and with a gentle pressure lift the cover from its position. Remove the faulty light bulb and replace with a new one. Replace the cover (spring lock). ACTIVE CARBON FILTER (filter models only): The carbon filter must be washed once a month in the dishwasher at the highest possible temperature using a standard dishwasher detergent. It is recommended that nothing else is placed in the dishwasher when washing the filter. After washing, the carbon filter must be reactivated by placing it in the oven at a temperature of 100°C for 10 minutes. Replace the carbon filter every 3 years. Fitting the carbon filter: 1. Remove the filter holding frame by turning the "g" knobs 90°. Fit the "i" carbon filter inside the filter holder "h". To refit the filter holder and the grease filter follow the inverse procedure. GB15 ITEMS SUPPLIED Remove all components from their packaged. [. . . ] Grease filter (above the perimeter suction filter). Control panel To select the functions of the hood simply touch the controls. These are engraved in the centre of the glass on the front of the hood 3 1 2 3 3 5 3 4 Off key (stand by) - Exclusion of electronic controls MOTOR OFF Press quickly to switch the motor off. EXCLUSION OF ELECTRONIC CONTROLS Press this key for more than 3 seconds to switch the electronic controls of the hood off. [. . . ]