User manual WHIRLPOOL DBRI 6910/IN INSTRUCTION FOR USE

[. . . ] Carefully observe the following instructions: • Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer's instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. • The appliance must be disconnected from the power supply before carrying out any installation work. • Regulations require that the appliance is earthed. [. . . ] This information may be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 RR-F 3 x 1. 5 mm) must be carried out by a qualified electrician. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with installation rules. GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. During use To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. SAFEGUARDING THE ENVIRONMENT Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol ( ). The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). - By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. Disconnect the hood from the electric power supply. Insert the blade of a small flat screwdriver where indicated by the three points, and with a gentle pressure lift the cover from its position. Remove the faulty light bulb and replace with a new one. Replace the cover (spring lock). ACTIVE CARBON FILTER (filter models only): The carbon filter must be washed once a month in the dishwasher at the highest possible temperature using a standard dishwasher detergent. It is recommended that nothing else is placed in the dishwasher when washing the filter. After washing, the carbon filter must be reactivated by placing it in the oven at a temperature of 100°C for 10 minutes. Replace the carbon filter every 3 years. Fitting the carbon filter: 1. Remove the filter holding frame by turning the "g" knobs 90°. Fit the "i" carbon filter inside the filter holder "h". To refit the filter holder and the grease filter follow the inverse procedure. GB14 501941833313:Layout 1 25-02-2009 8:51 Pagina 15 ITEMS SUPPLIED Remove all components from their packaged. • Assembled hood with motor, light bulbs, perimeter suction panel and grease filters installed. [. . . ] Keep in mind that upon completion of the installation, the minimum distance between the hood and the hob must be in accordance with the requirements listed in this booklet. Fix the two sections of the structure using a total of 16 screws (4 for each corner). Reinforce the upper section, if extending over the minimum length, by fitting 1 or 2 brackets (according to what included). Do this following the procedure below: a. [. . . ]