User manual WHIRLPOOL DC 5455 WS INSTRUCTION FOR USE

[. . . ] Note on installation and use: Read this manual before installing or using the hood. The Manufacturer declines all liability for any faults, damage or fires caused by the appliance as a result of failure to observe the instructions and recommendations given in this manual. This hood must be installed by a qualified technician. The installer must observe the installation distances indicated on the rating plate of the product/range. F INSTALLATION ET UTILISATION Remarque concernant l?installation : La distance minimum entre la surface de support des rcipients sur le dispositif de cuisson et la partie la plus basse de la hotte NE DOIT PAS TRE infrieure 60 cm pour les cuisinires lectriques et 70 cm pour les cuisinires gaz ou mixtes. [. . . ] By ensuring that this appliance is correctly scrapped, the user can help prevent potentially harmful consequences for the environment and the health of people. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. Disposal must be carried out in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. WARNING: To reduce the risk of accidents, electric shock, injury or damage, when using the hood comply with the basic precautions, including the following. Always disconnect the hood from the power supply before carrying out any installation or maintenance operation on the appliance. Installation must be carried out by a specialised technician, in compliance with the manufacturer?s instructions and local safety regulations. Earthing of the appliance is compulsory. Never use multisockets and extension leads. The electrical components must no longer be accessible to the user after installation. Do not touch the hood with wet parts of the body or use it when barefoot. Do not pull the appliance power cable to unplug it. do not repair or replace any part of the hood unless specifically indicated in the manual. All other maintenance services must be carried out by a specialised technician. When drilling the wall, make sure not to damage the electrical connections and/or pipes. The ventilation ducts must always discharge to the outside. The Manufacturer declines any liability for improper use or incorrect setting of the controls. IMPORTANT INSTRUCTIONS FOR SAFETY 12. The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. To reduce the risk of fire, only use a metal inlet duct. Children must be supervised so that they do not play with the appliance. The product must be disposed of in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. [. . . ] To remove it, pull the spring release handlesE1 backwards and remove the filter downwards. Over time, the metallic filtermay become opaque; this in no way affects its filtering capacity. Carbon filter - can be one of the following types: Shaped V1: Remove the cover W by turning the knobs O through 90. Insert the carbon filter inside the special housing and secure it in place by turning the knob O through 90, then close the cover. [. . . ]