User manual WHIRLPOOL DDB 5390 AL INSTRUCTION FOR USE

[. . . ] D INSTALLATIONSANLEITUNGEN Der Mindestabstand zwischen dem Kochfeld und der unteren Kante der Dunstabzugshaube muss bei Elektroplatten 50 cm und bei Gasherden oder kombinierten Herden 70 cm betragen. Schreiben die Installationsanweisungen des Gaskochfelds einen greren Abstand vor, ist dieser natrlich zu beachten. Sie sollten einen qualifizierten Techniker mit der Installation beauftragen. Folgen Sie bei der Installation der Nummerierung (1 2 3 . . . . . ). [. . . ] Packaging materials (plastic bags, polystyrene, etc. ) can be dangerous for children and should be kept well out of their reach. Product This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance. The mains power supply must correspond to the voltage indicated on the appliance rating plate located inside the hood. If provided with a plug, connect the hood to a power socket complying with current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the socket is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Electrical connections Cleaning the hood Important!Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. Packaging materials (plastic bags, polystyrene, etc. ) can be dangerous for children and should be kept well out of their reach. Make sure the hood has not been damaged during transport. Declaration of conformity PRECAUTIONS AND GENERAL RECOMMENDATIONS WARNING! ?The appliance is not intended for use by young children or persons with restricted physical, sensory or mental abilities or without experience and knowledge of the appliance, unless they are under the supervision or instruction of a person responsible for their safety. Children must be supervised so that they do not play with the appliance. Do not connect the appliance to the electrical power supply until installation is completed. Always disconnect the hood before cleaning or carrying out maintenance by unplugging it or switching off the power supply. Do not leave pans unattended when frying. Regular cleaning and maintenance is essential to correct functioning and good performance. Never use flammable materials as hoses for extracted air. If the hood is used together with other appliances powered by gas or other fuels, ambient negative pressure must not exceed 4 Pa (4 x 10-5 bar). [. . . ] Motor ON/OFF switch (display LED steadily lit). Timer/speed switch (display LED flashes). This switch operates the hood for a predetermined time: 20 minutes (speed 1), 15 minutes (speed 2), 10 minutes (speed 3), 5 minutes (maximum speed). Filter cleaning required: F warns of blockage of grease filter/s; C warns of blockage of carbon filter: When the carbon filter is installed for the first time, activate it by pressing keys E and F simultaneously for 3 seconds. [. . . ]